Search results

  1. alldodge

    2002 5,7 Mercruiser exhaust manifold keeps cracking - 5 times this summer

    What is your serial number and are you open or closed cool?
  2. alldodge

    No fuel in carb despite several attempts to crank

    Your right, I forget that Mod's can see deleted threads. I need to update my sig
  3. alldodge

    Mercruiser 5.7mpi horizon single cylinder burning lean

    Yes it checks out No not bad at all for me :) for you yes, I'm sorry :cry:
  4. alldodge

    150hp xr2 ignition switch

    This is standard wiring for 2 cycle WIRING
  5. alldodge

    Hydraulic Steering for Sterndrive

    I would suggest seastar
  6. alldodge

    Mercruiser 5.7mpi horizon single cylinder burning lean

    Your motor should have a MEFI-3 ECM (SN needed to verify) and it uses batch firing of the injectors. Batch firing means 4 injectors are fired at one time and normally fire at least twice for each revolution. Injector 2 and 4 are fired at the same time by the ECM. Swap 2 and 4 connectors to see...
  7. alldodge

    No fuel in carb despite several attempts to crank

    Might just have been a hiccup, it's working for me. Select the one in my sig and should take you there
  8. alldodge

    Mercruiser 3.0 wants to die only at 1800 RPM

    Sounds like the power valve. The power valve transitions the idle circuit to the main. Only way to fix it is get into the carb. Could replace the TKS with a standard carb
  9. alldodge

    No fuel in carb despite several attempts to crank

    After sitting that long it's not a tank vacuum Use a gas can and length of fuel line. If it fires up and keeps running then it's the antisiphone valve or the tank pickup If that doesn't work then it's the pump
  10. alldodge

    Starter not engaging flywheel

    Either the ring on the flywheel has moved, or the starter isn't moving the gear all the way out. Look closely at the ring and see if it's close to the starter or further away. Need to also rotate the flywheel and little at a time to see if there is missing teeth somewhere
  11. alldodge

    Mercruiser V174 Engine manual

    Welcome Manual 3 for the motor Manual 4 for the drive
  12. alldodge

    Trim Gauge troubleshooting.......

    Lower drive full down Remove starboard side gimbal ring sensor. Turn key ON and then turn sensor by hand to see if you can get it to move the needle. Get needle close to where it should be and reinstall for final adjustment
  13. alldodge

    Help! Overheating 3.0, not impeller or circulation pump

    It's about the size of a quarter and 3/4 inch thick behind the helm
  14. alldodge

    Engine failed to start after serpentine belt came off.

    What is your motor serial number? Over temp is always lack of water flow, so start with the impeller and pump. Remove thermostat and test in pot of water on stove with thermometer Get a short piece of clear hose and place it in between the pump and thermostat housing, at the housing. See if...
  15. alldodge

    Dying Engine/Electrical issues ???

    Might be the key switch. Have you checked with a voltmeter?
  16. alldodge

    Dying Engine/Electrical issues ???

    Pull both Positive and Negative both ends. Clean both ends and reattach. If there is a battery switch remove and clean those also
  17. alldodge

    5.7 EFI 2001 - clicking and

    Listened to it 3 times and my old ears cannot hear anything I would be worried. I'm sure it's there but I just can not hear it
  18. alldodge

    Getting challenging to find somewhat common items?

    Hope another helps to provide a better answer, but I buy all my filters online because I buy case size so get better deal then any local can provide That said, it doesn't help the local but then again, plan in advance helps
  19. alldodge

    Getting challenging to find somewhat common items?

    Most of the filters are so interchangeable these days , it should be easy to find a cross. Farm was the name many years ago so I bought 3 cases of the short filters and are Penzoil PZ- something (same as fram). Still have them but stopped using them because I started using Wix Wix and Napa are...
Top