Search results

  1. Scott06

    07 mercruiser 4.3 no start

    No get a volt meter and find out where you have 12 vac as outlined. Based on what you say in start you will have 12 v on positive terminal of the coil, hence the spark and running. In run you are losing it hence why it dies. It’s between the key switch and coil you are loosing 12 v . Start at...
  2. Scott06

    Choke valve position cold engine

    Typo dwell, ignition points dwell. Set dwell then timing. yes any tune up is done once it gets to operating temp. Get a factory service manual for your engine. Merc manuals have great detail on specs and procedures. If you have a modicum of mechanical knowledge a manual will help dramatically
  3. Scott06

    replace Mercruiser 2.5L 1989 with Mercruiser 3.0 1994

    that sounds right fully dressed (exhaust accessories etc) there is no real weight dif between a 2.5 and 3.0 they are essentially the same engine
  4. Scott06

    Hotter than normal temps. I just replaced the impeller on the sterndrive, and pulled the circulator pump.

    they usually last the life of the boat in fresh water. have never changed one even on 30 yr old boats. replace it if you want but that is not your issue here
  5. Scott06

    Hotter than normal temps. I just replaced the impeller on the sterndrive, and pulled the circulator pump.

    you probably were missing adequate water supply from the hose circ pump looks fine did you verify the gauge is accurate
  6. Scott06

    Choke valve position cold engine

    it may have been flooded or overly rich. Opening the choke and throttle will help clear a flooded or rich condition. when operating properly the choke will go fully closed but pops open a bit when the engine starts, then slowly opens more to full open when the engine warms up. Get it running...
  7. Scott06

    Oil Pressure Alarm

    yes clear plastic bottle about a pint in size
  8. Scott06

    No water coming out of the exhaust on muffs

    Exactly -only time I had an issue with the no choke was when I took the boat out in mid october (upstate NY) cold wet and rainy weekend in the 50's. a few min of warm up at fast idle was good to go.
  9. Scott06

    No water coming out of the exhaust on muffs

    either of them the element can be turned to force it open. When I had the element on my old boat just twisted the element such that it never came on. Ran it like that for many years, don't really need it much in warmer weather anyways.
  10. Scott06

    No water coming out of the exhaust on muffs

    No the opposite, if choke was closed the whole time it would explain why plugs are black and soot covered. When doing a cold start stabbing the throttle a couple times does two things. Sets the choke as when cold the choke will close , second the accelerator pump will push some fuel into the...
  11. Scott06

    No water coming out of the exhaust on muffs

    Depends on if it was loose enough that choke wouldn’t open. If choke stayed closed would expect it eventually would foul the plugs and not run Watch what the choke is doing when u get it running
  12. Scott06

    07 mercruiser 4.3 no start

    Use a VM to test Key switch could be the issue- so are you getting 12 v out of the key switch in run? If no probably the switch. if yes, then where are you loosing it from switch to coil? On a lot of boats the 12v come from key switch and daisy chains through the gauges, and probably a fuse...
  13. Scott06

    Only 3 Drain Locations?

    that may be depending on what cooling system you have I think you could have as many as 7 or as few as 1 (single point drain). issue is to make maintenance "easier" they hose over what were separate drain locations to a central or a fewer number of drain points. while in theory this is great...
  14. Scott06

    replace Mercruiser 2.5L 1989 with Mercruiser 3.0 1994

    I am assuming your old boat does not have power steering and the new engine does? the 8-10" long metal tube in the water intake hose is a powers teering cooler, this cools the PS fluid on the return line. Leave the cooler in the water inlet hose, remove the PS pump and 1/2" or so diameter hoses...
  15. Scott06

    Help me set up my new edelbrock 1409

    The over flow fuel line on the intake helps the fire start faster, so you don’t waste time just getting a whiff of smoke… the marine edlebrocks have a gold irrodite or similar finish vs the bare aluminum that the street carbs have. The bare aluminum corrodes in a car sitting in a garage … the...
  16. Scott06

    Rebuild my choke to Electric. What with the "holes"

    Yes and we know you have enough pictures already to start your quadrajet only fans site… if you know the principles of how it should work you don’t need a manual and can figure it out.
  17. Scott06

    No water coming out of the exhaust on muffs

    No what do lugs on cap look like? Mine tend to get green oxidation after a few years.
  18. Scott06

    Over heat alarm

    There are three switches on engine which can make alarm sound - high engine temp, low oil pressure, and low drive lube bottle . All three of these switches make the ground connection to the block for the buzzer. Thsee are completely separate from oil pressure and temp senders that work the...
  19. Scott06

    1990 mercruiser 4.3 no spark

    Turn distributor while cranking. If backfiring yes timing is wrong reading this wonder if you had a grounding issue on distributor to block . Not sure if third wire off sensor is a ground which would nix my theory… but if clamp is loose …
  20. Scott06

    MC1 anodes

    What prop are you running. I had zero issues with aluminum annodes in fresh when I ran aluminum props. went to a big 4 blade revolution 4 and had some pitting like u mention. This is lift kept not in a marina not connected to shore power. also found better results with oem merc magnesium vs the...
Top