Search results

  1. K

    Dealing with bogging for too long and need help because I've done just about everything!

    Does your engine have a knock sensor that controls the ignition timing? Also as AD and SD suggested have you tried monitoring the fuel pressure with the boat running as you normally use it?
  2. K

    Mercruiser 3.0 12" and 14" flywheel interchangeable

    If the spare couplers are the style that are triangular in shape that had 3 mounting points then they should bolt to your flywheel. The kind you cannot use are the type that bolted to the 6 crankshaft studs that mount the flywheel.
  3. K

    loss of power over 3500 RPMS FYI

    Have you ever tried using a 6 gallon outboard tank? That will narrow down the problem to either point to the tank or the engine’s fuel system.
  4. K

    Buying a used boat with Mercruiser 228

    Raw water cooled should indicate close to 160* or less at all rpms. With the drive down in the water in neutral, steer lock to lock and listen for drive line noise that changes.
  5. K

    loss of power over 3500 RPMS FYI

    Another trouble area is the fine mesh screen inside the suction tube. That screen causes a lot of problems.
  6. K

    Water in the Oil +

    That is what it appears to be. Break out the tools. Has your engine ever had a overheating problem?
  7. K

    Burning ~3 quarts of oil between changes

    One thing I learned about PCV valves. Years ago my son had a 86 Crown Victoria. It would belch out oil smoke from time to time. Turned out the cure was a genuine Ford PCV solved the problem. One of the mechanics at the local Ford dealer told me to try one.
  8. K

    SX-M Drain Hole

    Just remove the dip stick and try a 3/8” 16 bolt. If it screws in easy then the drain will be the same.
  9. K

    145 a volvo penta winterize procedure

    Check the antifreeze with a coolant hydrometer which is available at most auto stores, that will tell you the amount of freeze protection. So yes leave the antifreeze in the engine.
  10. K

    Is this raw water pump serviceable?

    If the pump was keeping the engine cool then just replace the part in question.
  11. K

    1976 OMC stringer electric control box removal

    What makes you think that the switch is at fault? There is a feed from the ignition side which will be red or purple, 2 white wires which are the neutral start, if there are green and blue wires, green is “go,” blue is “back up.”
  12. K

    Is this raw water pump serviceable?

    I there a VAT on the pump and parts In the UK?
  13. K

    Loud squeal and no idle. Replaced head gasket, put engine back together now this…. :(

    It sounds like the starter is staying engaged when the key is released.
  14. K

    1976 OMC stringer electric control box removal

    To separate the control from the mounting bezel get a punch and a hammer and un screw the center ring nut, it is a right hand thread. A few taps usually will loosen it. I believe there are some of those tubular switches on e bay. First check it with an ohm meter, the problem may be elsware.
  15. K

    Is this raw water pump serviceable?

    You never mentioned that you were in the UK. I now understand your plight. If you have the tools and ability then take a shot at repairing It. Here in the “colonies” we are spoiled with lower prices for those type of things.
  16. K

    Maintenance on 20 year old VP 3.0 inboard.

    Remove the spark plugs, quart sone Marvel Mystery oil then spin it over with the starter. Has the engine block and manifold been drained to prevent freeze cracking?
  17. K

    Tachometer bouncing

    Be sure the bracket and bolts that secures the starter brush end is tight against the engine block.
  18. K

    Mercruiser 3.0 Trouble Starting

    If you think there is water in the carburetor you will have to at least remove it, flip it over in a clean bucket to check. If there is none then re mount it. Otherwise it needs to be taken apart and cleaned. You may not need new gaskets if you are lucky. Or just get a kit from Sierra. #...
  19. K

    Volvo Penta Ford help

    A then there were thr Holman Moody conversions. I had the good fortune to talk to Ray Moody years ago at his shop in Charlotte, NC. He told me it was a crazy time and they were shipping the Ford/Volvo packages as fast as they could get them out of their Florida shop. Ford was cutting them...
  20. K

    Is this raw water pump serviceable?

    Save yourself a headache and get a new pump.
Top