Search results

  1. flashback

    Chris craft scorpion wiring diagram

    Had an old clymer manual here's a picture of it. Hope it helps...
  2. flashback

    Am I getting water of of fuel path Properly 150's J150VXCIS 2001 carbed 150'

    Here where I live marina gas at the beginning of summer is iffy.. the tanks sit all winter and tend to collect water..
  3. flashback

    Another Q about this '71 9.5hp

    So you're saying if the cam lobe is pushed down it will realign with the woodruff?
  4. flashback

    Best boat lettering removal?

    Or live with the name already there 😄
  5. flashback

    Over-Temp alarm installation

    You might be able to add or subtract resistance on the sensor by adding a simple resistor somewhere in the circuit. The electronic wizards around here could verify...
  6. flashback

    Over-Temp alarm installation

    Yeah I can relate.. but we still can dream...!
  7. flashback

    Over-Temp alarm installation

    I'll be the relay!
  8. flashback

    Over-Temp alarm installation

    You probably will need to add a relay if using a disco ball..:)
  9. flashback

    Out on the Lake Pictures

    Nothing fancy but it's my river! LOL
  10. flashback

    Repairing damaged floatation foam

    You can't repair it, dig it out and replace or not..
  11. flashback

    Replaced Bellows now gears won't engage fully?

    You got to get your mind right! It's not a nightmare but a challenge..if you have some left handed bits available they may even get it out in one piece.. luck!
  12. flashback

    Replaced Bellows now gears won't engage fully?

    If you are successful getting the mess out you will need to chase the threads with an appropriate tap.. there is no stress on this fitting so test the new fitting and if the threads grab then install with perfect seal so you don't have this situation again..
  13. flashback

    Replaced Bellows now gears won't engage fully?

    It's essentially a pipe fitting and you twisted the head off. I would drill it out with a smaller bit stepping up in size until it's thin enough to pic out assuming it's brass...
  14. flashback

    Replaced Bellows now gears won't engage fully?

    Thx, better late than never...I don't weld so I spent an hour grinding flats on a deep well until a larger one would fit the flats..:)
  15. flashback

    Replaced Bellows now gears won't engage fully?

    Now you tell me! How long has it been like that? LOL
  16. flashback

    Garelick pedestal seat

    Mine have nothing on the stand just the open tube.
  17. flashback

    Fuel dumping in 5.0 cobra 1994 mechanical pump, not electric.

    There's a small hose coming from the pump to the air horn on the carb. If that's the vent you speak of then the pump is failing..
  18. flashback

    Garelick pedestal seat

    I'll clean things up and it should work fine, the engine and drive seem to be working and I'm finally getting to enjoy the boat this year..
  19. flashback

    Garelick pedestal seat

    Here's a picture, after cleaning the crud it does appear to have a nylon disk in the socket. Probably could use a bit of silicone lubricant.. Watcha think?
  20. flashback

    Garelick pedestal seat

    I'll get a pic soon, but as you said, it probably needs a bushing...
Top