Search results

  1. flashback

    Acting like a spun prop hub but it's not. What do I try next?

    Well I don't want to find outThat's for sure!
  2. flashback

    What is wrong with my alternator

    Think you meant 13.8 volts and if it's putting out 50 amps it would get hot. Must be a weak battery. Nice pic!
  3. flashback

    Acting like a spun prop hub but it's not. What do I try next?

    I'm guessing you could smell a spun coupler.
  4. flashback

    Converting from vertical 2x4 to horizontal 2x6 bunks

    Cedar would be an excellent choice.
  5. flashback

    2002 Mastercraft 5.7 harmonic balancer moving in and out

    Actually says a lot for how the crank is mounted I think..
  6. flashback

    Converting from vertical 2x4 to horizontal 2x6 bunks

    I think your over engineering it a bit but it's your boat. fillet is not necessary IMO. and even using yellow pine lumber will last you many years, The PT lumber these days ain't what it used to be..
  7. flashback

    Converting from vertical 2x4 to horizontal 2x6 bunks

    I agree with the above posts but if I wanted to do what you suggested I would just glue and screw the 2x6 on top of the 2x4..
  8. flashback

    Troubleshooting a leak

    It doesn't look life threatening, my kitchen faucet drips more. Another option is the seal for the raw water tube, they can take a beating when changing the hose..
  9. flashback

    Troubleshooting a leak

    Pic's a little dark but your arrow seems to be pointing at the hull drain, you didn't forget to put the plug in did you?
  10. flashback

    Speedometer tube

    Don't see why not, but you'll need the fitting to fit the drive.
  11. flashback

    Plastic Tanks are All Junk

    This is something that I will be sure to remember! Thx
  12. flashback

    Gas cap replacement

    Most all I have seen have a tether on them so don't be too hard on dockboy..
  13. flashback

    How to test bonding/grounding using a multimeter

    Battery - post
  14. flashback

    Can water get into oil from failed exhaust parts?

    Why did you take it apart?
  15. flashback

    Can water get into oil from failed exhaust parts?

    Valve position has no effect on the pressure test.
  16. flashback

    Can water get into oil from failed exhaust parts?

    I don't believe there is a practical way to pressure test manifold or elbow. That test is done with acetone.
  17. flashback

    Lubricating throttle/shift cables

    Some controllers have a tension adjustment or the controller itself may need attention.
  18. flashback

    Wiring Fuel Pump Relay to Alternator

    I pulled power from the + on the coil, it was close to the relay. No problem yet. My goal was to keep the wiring simple and compact.
  19. flashback

    Boat dies in the water

    That's interesting, how did it end up down there?
  20. flashback

    Should there be a Sleeve Propeller Bore on 200HP Merc 3.4L V6

    Do you think it may have a steady miss?
Top