Search results

  1. flyingscott

    Are BPZ8HS-10 and BP8HN-10 Spark Plugs Interchangeable?

    Here is a service bulletin for those motors
  2. flyingscott

    Help! 1992 Johnson Tracker 60hp pro series

    Those motors have decompression holes in the cylinder.
  3. flyingscott

    Help! 1992 Johnson Tracker 60hp pro series

    What would you expect those compression readings to be?
  4. flyingscott

    under powered mercury 125 / 2 stroke

    If you get the manual you can do the tests. You need the manual!!!
  5. flyingscott

    under powered mercury 125 / 2 stroke

    Well your 19" pitch is nor helping matters. Do you have your manual yet? What yr is your motor? If an early one classic signs of high speed windings failing.
  6. flyingscott

    20HP misfiring

    Might be a lean sneeze. Try opening the low speed screw a little bit.
  7. flyingscott

    under powered mercury 125 / 2 stroke

    That is a 2+2 motor so it idles on the top two until 1800 rpm then the bottom 2 cylinders come in. Need a factory manual to set this motor up correctly.
  8. flyingscott

    under powered mercury 125 / 2 stroke

    Doesn't post #1 say 130 psi on all cylinders?
  9. flyingscott

    under powered mercury 125 / 2 stroke

    How long have you owned this motor? Did this happen recently? Do you have a factory manual? Were the carbs removed recently? Link and sync done correctly? Accelerator pumps working? Factory manual is a must have for this motor
  10. flyingscott

    What brand of 2 stroke oil do you use for your Johnson Evinrude 2 stroke

    I use xd100, bought a bunch of it cheap. It works well as a pre mix.
  11. flyingscott

    97 Johnson 50hp 3cyl - idle problem

    Your motor has decompression holes, 110 is not that bad for your motor. I would look at the quick start and for any broken or worn linkages.
  12. flyingscott

    Replace 2002 115hp lower unit

    Are you sure a 2007 lower will fit on your motor? Should make sure before you spend the money. Not all 115s are the same.
  13. flyingscott

    1957 Johnson 18 hp. FDE-11

    Here is a dumb question, are you using a 2 line pressure tank?
  14. flyingscott

    88 110 evinrude vro v4

    Do a compression test. Was the waterpump serviced recently? Does it make a difference if you pump the primer ball?
  15. flyingscott

    Merc 25hp 2 stroke electric start issues

    Yes I believe it is.
  16. flyingscott

    1975 evinrude 15504C engine cover...argh!

    If it does not have lube in it and has been sitting a while, the tranny fluid will help lube and clean it. That's why you let it sit a couple days. IF it had lube in it should be fine. BUT if the shift rod is stuck in the bushing, then tranny fluid can help lube it.
  17. flyingscott

    1975 evinrude 15504C engine cover...argh!

    The prop has to be moving to shift properly. Also take the lower unit to see if that frees up the shift handle. If it does the problem is in the gear case. Does the gear case have lube in it? If not fill it with tyranny fluid and let it sit a couple days.
  18. flyingscott

    Merc 25hp 2 stroke electric start issues

    I believe the neutral safety switch only locks out the electric starter.
  19. flyingscott

    Merc 25hp 2 stroke electric start issues

    clean every wire to shiny and check the neutral safety switch in the controller.
  20. flyingscott

    Merc 25hp 2 stroke electric start issues

    is this a tiller or remote model?
Top