Search results

  1. jimmbo

    Points/condenser conversion kit

    Tune up Kit Sierra 18-5006 Evinrude Johnson OMC BRP 172522
  2. jimmbo

    Johnson Outboard 9.5 1973 9R73B can hardly pull start with spark plugs in but with plugs removed pulls very easy

    Perhaps you should remove the Plugs and pull the Starter Cord, rapidly for, say , about 50 pulls. You may have poured enough of the Snake Oil in to cause Hydro-Locking.
  3. jimmbo

    90HP Mercury pushing 24' pontoon

    Stock Prop? Mercury does not ship Engines above 25hp with Props. What do you consider "sucking up the Fuel"? 9 gallons/hr would be an Acceptable rate of Consumption
  4. jimmbo

    Johnson vs Merc

    Only you can decide which to buy. I have owned both Mercs and Johnson-Evinrudes, and I can say they a both Good, or both Junk. The Mercs tend to be a little more Finicky when it comes to tuning, but that is because of more Hp per cubic inch Displacement. If you plan to use the Boat for Skiing...
  5. jimmbo

    Johnson vs Merc

    Both are fine engines if maintained. However there are major Differences between them. Mainly Displacement. The Johnson has 50% more Displacement(99.6 vs 66.6 for the Merc) which means a lot more Torque. The Johnson is also Prop Rated, and the Merc is Crank Rated. Top Speed should be within 3...
  6. jimmbo

    1997 Mercury 9.9 Vent screw turning on air

    What is the Serial #? There are many 9.9s and the Serial # is need to access the proper Parts Diagram. On some 9.9s there 2 Vent Screws side by side. Some JB-Weld Quick might permit the screw to be pulled on as it is rotated
  7. jimmbo

    5.7 vortec pertronix and Holley big carbs timing

    What is the part # of the Carbs? It would be on the Air Horn. Do both carbs have the same Spring in the Vacuum Control. Holley makes several, and they will change the Rpm the Secondaries start to open, and how quickly they open. All Holleys, have Idle and Off Idle Circuits on the Secondary Side...
  8. jimmbo

    crest liner 14 sportsman on a ez loader trailer

    Depending on the Ramp, but I never get my feet wet on this Ramp, launching or loading. Sometimes I don't even back in this far
  9. jimmbo

    New prop for my boat

    Normally I would say; No. Changing the prop is not going to give you any more speed. For that you need more power. That said, what is the WOT Rpm range for that Engine? If you are under propped, then an increase in pitch will bring down the Rpms and might give you another 1/2 - 1 mph more top speed
  10. jimmbo

    Battery...

  11. jimmbo

    40hp '67 super seahorse top speed.

    Welcome to iboats Many factors come into play when it comes to top speed. Engine Condition, is only one. Is the Engine propped to run in upper 1/2 of the WOT Rpm Range. On that Engine it is 4000-5000rpm. I would guess that 12 inch Pitch would be a good starting Altitude The condition of the...
  12. jimmbo

    Battery...

    Think what you want, and Rationalize what you think to suit your thought pattern, but Impellers go bad very fast when starved of Water.
  13. jimmbo

    Battery...

    Water is the Lubricant, so when it stops arriving, it is no different than a Dry Start.
  14. jimmbo

    pulls right at wot

    They should make every Steering Wheel for Boats with about 25 Spokes, that way no one will ever get Their shorts in a Knot about it not being centered, or the Centering changing when the Trim is adjusted
  15. jimmbo

    Raising transom height on 12' Tinny. Worth it?

    I wonder if the Province will survive another wacko Right Winger? I doubt ditsy will be around much longer. A *ell bent Separatist is in control of the Unstable Clown Posse, and will force Smith out, and place himself as another Unelected Leader I remember the Drunk staggered into a Homeless...
  16. jimmbo

    Raising transom height on 12' Tinny. Worth it?

    Genghis Klein really Effed things up in this Province. 20 yrs ago I met Ray Cardinal, a Minister in the Klein Government at my Cousin Cottage. I certainly had Words with him about how they messed up the Electrical System. He admitted they hadn't thought that the City owned Edmonton Power would...
  17. jimmbo

    Raising transom height on 12' Tinny. Worth it?

    If you get a Portable AC, make sure to get one of the 2 Hose units, that way it is using Outside Air to cool the Condenser, then returning it outside. The single hose units are using Inside Air to cool the Condenser, then sending it outside, and it has to be replaced by Hot Humid Outside Air.
  18. jimmbo

    Raising transom height on 12' Tinny. Worth it?

    The past 6 yrs the Humidity in Edmonton is between 95 and 100% every Night from late April till early Nov. All the new Storm Ponds are part of the Problem, as they create vast amounts of Evaporation, during the Hot Days, then when the Temp drops around Sunset the Dew Point hits and 100%...
  19. jimmbo

    Raising transom height on 12' Tinny. Worth it?

    My Mental Midget Brother, likes to open all the damn windows to let all the 100% humid air in at Night, then Closes them during the Day, and now he wonders why he has Mold on the walls.
  20. jimmbo

    5.7 vortec pertronix and Holley big carbs timing

    Big Holley Carb, really don't say much. But a 5.7 turning 5000rpm, with a VE of 80% is only gonna need about 430cfm. So a 600cfm is more than enough, anything bigger is just a waste and the Primaries too big and that can lead to poor Off Idle response. Are both Carbs you have the same Part #...
Top