Search results

  1. F

    14' SC Rebuild

    Another layer of support under the gunnels before starting some trim strips
  2. F

    14' SC Rebuild

  3. F

    14' SC Rebuild

    Finding myself relearning the site. Jumped ahead and placed numbers in place, building a bow trolling motor deck and modifying the Bimini top from my old boat to fit this one. Will have to cut about 5 inches out of the width.
  4. F

    14' SC Rebuild

  5. F

    14' SC Rebuild

    Wow, time really flys on by, almost three years, a pandemic, heart attack and open heart surgery later and here we are! Feeling good and getting back to it, the little boat has waited patiently for me and it’s time to finish her up and get her wet. This week I’ve been making adjustments to the...
  6. F

    Definitive No-bleed through painters tape??

    Any suggestions? Not worried too much about cost, just want it to do a good job. thanks
  7. F

    14' SC Rebuild

    My Sprayit kit arrived last night. Looking forward to life after rattle cans. Looks like a couple days of much needed rain, heading out on a scavenger hunt for assorted bolts, screws and hardware needs as well as a couple more hole saws to finish the vents. On a side note, the Sprayit system can...
  8. F

    14' SC Rebuild

    Last of the old rot coming out and starting to fit new wood in. Once that is done I can start planning bright work.
  9. F

    14' SC Rebuild

    Should oil have come out like this? Or could it have been where I had it laying down a few weeks until I built a stand for it? It's a'73 E-rude.
  10. F

    14' SC Rebuild

    First try at a vent for the rear bench seat, need a few more hole saws to have each hole an ascending or descending size. thought some type of vent would look better than just an open gap on both ends of the bench.
  11. F

    14' SC Rebuild

    There it goes...
  12. F

    14' SC Rebuild

    Grabbed the yak and took a couple of hours off the boat remodel. A few pannies for the effort.
  13. F

    14' SC Rebuild

    Starting to reinforce the hatches for no twist or sag.
  14. F

    14' SC Rebuild

    Transom in, used two existing holes near the center to draw the two pieces together until the 5200 sets. Clamped the upper edge for now, goi ng to check the transom cap the see if it will work in place of the clamps.
  15. F

    14' SC Rebuild

    Working on getting the bunks and rollers adjusted this morning. Bunks are now hugging the boat hull much better and I think in time will conform to the hull shape even more. Starting to cut off bottoms of bolsters and rollers now, will need to go back and even them up a bit where I cut them out...
  16. F

    14' SC Rebuild

    Final fitting of the transom, primed and painted interior aluminum. Rain moving in will be working in shop to over drill and then fill transom holes. Painted the winch and installed the new strap. If rain holds off a bit will final adjust bunks and rollers and grind off the hanging bolster so...
  17. F

    '71 Johnson 20hp starter rope mechanism?

    Hi, I'm looking at this OB to buy, owner says the starter rope rewind mechanism shot. Should it be fixable, and what else should I be looking at? Thanks,
  18. F

    14' SC Rebuild

    Hi, just saved this boat from the scrap metal dealer, will be gutting it down to bare metal and starting over. Can't figure out what model it is, any thoughts on that? Thanks, frazoo Edit, working on posting pics, be back soon.
View older results
Top