Search results

  1. R

    1995 Evinrude E90TLEO charging

    The stator to ground should read INFINITY.-----400 ohm indicates a short to ground.----Replace stator.
  2. R

    2 stroke longevity?

    Two strokes last a long time.----Most end up on the scrap heap because of mistreatment / mistakes made by owners.-----Ever see a jet skier in operation ?----near constant idle to full throttle all afternoon long.----I call them ----" bumble bees "
  3. R

    1995 Evinrude E90TLEO charging

    Replace the stator.
  4. R

    New to me 18 hp Evinrude.

    But you have to remove the magneto plate in order to properly install new coils !
  5. R

    1995 Evinrude E90TLEO charging

    Needs to show about 13.5 / 14 volts at full throttle.
  6. R

    Reduced speed under load

    factory kits.-----No special tools needed.
  7. R

    Reduced speed under load

    Definitely ---NOT---electric shift.
  8. R

    Water leaking

    I doubt that a 2000 model uses an O-ring below the driveshaft splines.
  9. R

    cowl air inlet on mercury 9.9.

    Would that be a 9.8 model?----Serial # is ?
  10. R

    1975 Johnson 70hp

    One one of those should go 35 MPH.----That is with a motor that is producing it's rated power.----Using a 17" pitch prop?
  11. R

    Struggling with shifter/throttle cable installation on Johnson 25 HP

    Time to visit a boat sgop.----Perhaps get the correct control and cables.
  12. R

    Reduced speed under load

    I would say the motor is a 1975 model.-------A 1973 is listed as a 50373R-----A 1974 model is 50473M
  13. R

    Struggling with shifter/throttle cable installation on Johnson 25 HP

    If it is a single lever control , the shifter cable is the first one that moves.
  14. R

    Reduced speed under load

    According to your model # it is a 1975 and no electric shift.----Do you agree?
  15. R

    are there boat "salvage yards" anywhere in the U.S.?

    E-bay is a great resource.----Looking for engine parts or actual boat parts.
  16. R

    1976 115hp low to no spark

    A 50 year old motor.----Some will argue.----Step #1 is a compression test.----Post the actual values here.----Then test charge coil and sensor coils with your ohmmeter.
  17. R

    Reduced speed under load

    The motor appears to be a 1975 model.----There was no electric shift on 1975 models.----Make sure carburetors ( high speed jets ) are clean.----
  18. R

    Retaining ring on1975? Johnson

    OMC produced motors way after 1973 !----Post pictures.
  19. R

    Retaining ring on1975? Johnson

    Flat side is up.---Disregard the cutout section.
  20. R

    18 or 25? Anyway to tell?

    So you found a number as clearly stated there would be.----#72 was used on 25 HP models.
Top