Search results

  1. Scott Danforth

    Float bags for small bow boats?

    Kayaks are not required to meet ABYC H-8. boats are
  2. Scott Danforth

    Let's talk skill...

    google V-hull wander. all single prop V-hulls do it. duo-prop singles also do it to a slightly lesser degree. Not a thing that you can do to stop it but let it wag back and forth.
  3. Scott Danforth

    Mercruiser dies after getting on temp

    points when cranking get their voltage from the starter "R" terminal (also called "I" terminal). however for normal Key-on, they get power thru a resistor wire, or a ballast resistor to drop voltage to approximately 9 volts. you can run them "hotwired" to 12 volts for a short period of time...
  4. Scott Danforth

    Need different prop for pulling

    unless your motor was built to need higher octane, it will NOT give you more power, it will give you less power and cost you more money at the pump as Octane goes up, the ability for the fuel to ignite is decreased (allowing a higher base timing to move the timing curve). This is increased...
  5. Scott Danforth

    Need different prop for pulling

    when I had a 3.0, I had 3 props with me. a 19p for WOT runs, a 17p for most things and a 15p for watersports as Jimmbo stated, your boat is a bit much for a 5.0 your 3400# dry weight will be closer to 4200 once you add batteries, gear, fuel, etc. I would shoot for a 17p myself if you...
  6. Scott Danforth

    Let's talk skill...

    600 RPM is OK. 800 RPM is too high
  7. Scott Danforth

    aluminum prop comparison

    need to see what RPM you are turning at WOT with the throttle lever mashed lugging a motor will not only kill it, it will burn more fuel. see the first sticky in the prop forum. have the answers to those 6 questions.
  8. Scott Danforth

    Stalled and never started again

    even new points in a package need the contacts filed. a film of corrosion will cover the points from non-use and they simply wont fire. being a 3.0, rough gap at 0.016", set dwell to 32 degrees, set timing to 4 BTDC. if the dwell meter doesnt show a reading while cranking, go back to the points.
  9. Scott Danforth

    '71 Starcraft 21'. I/0 Merc. Spark interrupter switch???

    go to the top of the mercruiser forum, and look at the stickies.
  10. Scott Danforth

    Stalled and never started again

    first, welcome aboard second, its nearly never the coil third. explain how you set the points. most likely the initial issue was the points needed adjustment. did you file the points? did you set the rough gap? what was the dwell? what did you set the timing to?
  11. Scott Danforth

    Mercruiser dies after getting on temp

    something not right. should be ~8-9 volts when engine running at the coil, and battery voltage when cranking make sure to get a points file (or use one of your wifes emery boards) and a dwell meter along with the feeler gauges. the points file is to dress the contacts, the feeler gauges are...
  12. Scott Danforth

    Aftermarket fuel pump recommendations

    do a google search for the forums. you can just replace the airtex pumps in the fuel pump assembly. about $200
  13. Scott Danforth

    Engine, Carb or Prop? need suggestions or ideas please.

    The coupler for a stringer does not care about the flywheel, only the crank pattern The only Stringer coupler for GM motors only fits the 1985 and older 2-piece RMS cranks
  14. Scott Danforth

    Engine, Carb or Prop? need suggestions or ideas please.

    There is no 2-piece RMS button coupler for a stringer 800 that I have found , and the 1-piecs RMS pattern is different. The bolt circle on the 2 piece rear main seal crank is 3.58" while the 1 piece is 3.00" bolt circle The Ford pattern is close to the 1-piece.... however with one hole rotated...
  15. Scott Danforth

    Engine, Carb or Prop? need suggestions or ideas please.

    how did you mate up a 4.3 to the stringer drive? only the 1985 4.3 has the right crank (2-piece RMS) to mate up to the OMC button coupling unless you had a button coupling custom made are you sure the motor is not the 3.8 liter? with your boat being a 1984, the 4.3 didnt exist yet. the 1985...
  16. Scott Danforth

    1998 5.7 Freshwater cooling kit info

    this should be the connections for the VP half system (going off of memory from 2008). reach out to your local dealer with the engine serial number and they can get you the correct diagram.
  17. Scott Danforth

    Let's talk skill...

    first, what is your idle speed? should be 650 RPM in gear at idle.
  18. Scott Danforth

    Keep blowing my starter solenoid up.

    got a picture of the wiring to your pilot relay? pretty sure the wiring needs some TLC.
  19. Scott Danforth

    1998 5.7 Freshwater cooling kit info

    factory service manual has the plumbing diagram. do you have the deaeration tank?
  20. Scott Danforth

    Lowe '08 20'

    Aftermarket add on for changing room curtain Do you mean gas spring? If you have an outboard, there isn't any. If you have an IO, look at the old one for the part number, length and force Google tongue weight. Plenty there I wouldn't tow with a mooring cover, it will most likely blow up...
Top