Search results

  1. R

    1990 Force 120HP no spark NEW stator tests 0.5V between sets open resistance this is crazy HELP

    These motors sure are causing you a lot of issues.-----Perhaps time for other motors.
  2. R

    DESPERATE situation

    Post a picture of the vent hole.----It is NOT CLEAR as to what the situation is at this time.
  3. R

    99 Johnson 200 shift/throttle issues with new cable

    Propeller must be turned when shifting a non running motor !
  4. R

    Tilt/Trim Problems

    Salt water motor ?-----Corrosion between plastic bushings and the aluminum might be jamming up the pivot points.
  5. R

    1975 Chrysler 75 HP Outboard Weird Spark Issue

    Is the battery big enough?---And have you had it load tested ?
  6. R

    1979 80HP Mercury

    Bulb has to go hard.----So you have a leak.----Inspect INSIDE your fuel tank.----Some plastic tanks are junk.-----Check fuel pump diaphragm.-----Check float valves.-----Once motor has started the bulb does not need to be hard.
  7. R

    1975 Chrysler 75 HP Outboard Weird Spark Issue

    Weak battery.----Load test required.---Bad starter.----Take it apart and do some testing on it.
  8. R

    1975 Chrysler 75 HP Outboard Weird Spark Issue

    Starter may be drawing too much power.
  9. R

    1979 80HP Mercury

    Do choke flappers close when you push the choke button?----Are choke flappers a tight fit ( not warped)
  10. R

    1979 80HP Mercury

    Do you push the choke to be on all the time while cranking it over?
  11. R

    1979 80HP Mercury

    Load test the battery.----Take starter apart for inspection and ohm test on armature.----These steps are important and cost no beer tokens.
  12. R

    I Got Me a Mercury !!!

    Have you had this motor apart ?----Upper and lower crank seals go bad on these after 50 years.---Labarynth seal in reed valve block wears.---Reeds can break / chip.-----Rings wear.----No overheat protection on these and often have scored pistons / cylinders.
  13. R

    1979 80HP Mercury

    Help the forum help you by posting the actual compression values.----Do you raise the fast idle lever for cold starts?-----Do choke flappers close when key is pushed in , or button is pushed?
  14. R

    1996 115hp can't get starter to engage

    With a " flywheel cover " it must be a 60 degree motor.
  15. R

    1975 Johnson 70hp

    If those are accurate compression values , there is an issue.-----Remove cylinder head and inspect.----Values should be at 140 PSI.
  16. R

    Evinrude 75hp 1976, difficulties accelerating

    Post the actual compression values here.
  17. R

    Idle Issues - 1980 Johnson 115 - J115TLCSA

    Post the actual compression values here.
  18. R

    1988 70hp vro throttle

    The red lever on the electric primer valve should be inline with the valve body for the " run " position.---Pointing to the back of the motor.-----Do a complete evaluation of this motor before spending any beer tokens on it.
  19. R

    1988 70hp vro throttle

    The red lever on primer valve is in the wrong position.----And what are you using to operate the throttle.-----The small lever or the main lever.-----Perhaps find a manual or a coach on how to operate the motor and the control box.
  20. R

    1990 Force 120HP carbs mix adjustment help

    Use a dial indicator.----Post an accurate measurement of how much movement you get at the flywheel.----Is it 0.003" or 0.013".----No guessing on things like this.
Top