Search results

  1. Lou C

    Bow U bolt Eye Tie Down Repair Question on a 20' Bowrider.

    Agreed not knowing how thick that area is, you want something to spread the load out, like maybe 1/8th" alu plate if you can get it cut to size, or galvanized steel plate. You can use wood but just make sure to really coat it in resin. PS I had to rebuild all the gas tank mounts for my boat...
  2. Lou C

    This happened today, and in the blistering heat.

    If you wind up replacing any rotted wood there I'd coat it with resin and seal the holes for the u bolt with Lifeseal or 4200 to prevent a recurrence.
  3. Lou C

    Thinking about upgrading to AGM batteries

    Might just want to check the charging voltage of your system, AGMs don't do well if they get overcharged.
  4. Lou C

    This happened today, and in the blistering heat.

    A good warning to all of us with old boats to CHECK THAT! especially with a roller trailer!
  5. Lou C

    Impeller Question with Rabbit Ears On

    160* stat on my 4.3, runs right at 160, might rise to 170 after coming off plane. Merc can have a 140 (older models) or a 160 (newer models), I'm guessing you have a 140, so that's about the temp you should run at. On your gauge, it should be on the hash mark between 100 and 175, that's probably...
  6. Lou C

    Thinking about upgrading to AGM batteries

    I added AGM batteries to our 2007 Grand Cherokee & 2017 Subaru with no issues….might consider them for the boat next time.
  7. Lou C

    Does anyone remember when car & boat engines only had.

    What I try to explain to people is this: Yes, modern computer controlled engines are more reliable than old school engines BUT: With modern computer controlled engines there are many more possible points of failure which can make troubleshooting & repairs more difficult when something does go...
  8. Lou C

    She just won't start easy nor stay running 4.3l

    Also if it’s back firing thru the carb you might have an intake valve that’s hanging open or not closing all the way. Any water in cyls after running?
  9. Lou C

    Impeller Question with Rabbit Ears On

    What temp is your stat? Should be close to that
  10. Lou C

    2002 Volvo 5.0 GXI Low Operating Temperature

    The other thing that's a common problem, is a grain of sand or rust flake caught in the 'stat, it keeps it from closing, it will never warm up till you run it on plane for a while. Sometimes that clears it out. I've also had luck with running it up on plane, bring it back to idle, and then tap...
  11. Lou C

    Need to vent....

    if you can send that vid, or a screenshot to NHTSA also try a local new channel that does consumer protection stuff they are incompetent fools Better yet fill up a couple five gallon cans drive back to the dealer have the shop manager come out put gas in....let it happen just like your vid...
  12. Lou C

    Does anyone remember when car & boat engines only had.

    Well yes, my first vehicles were air cooled 1200 cc VWs with simple points distributors 1 bbl Solex carb & 6 volt generator. The boat I still have isn’t much more advanced with a Prestolite points distributor 4 bbl Quadrajet; about equivalent to a late 60s Chevrolet. Just the way I like it. If I...
  13. Lou C

    Dead Batteries

    Could be; doesn’t take much!
  14. Lou C

    86 Larson DC21 Engine Help Please...

    First thing if you’re keeping the OMC drive system which one do you have, Stringer or Cobra? Reason being is that the stringer drives used pre 1986 engines with 2 piece rear main seals, the Cobra drives all used one piece main seals. So with that the flywheels are different so you have to stick...
  15. Lou C

    Dead Batteries

    Wing nuts holding down battery terminals on the battery? If so replace with self locking nuts. I use marine grade battery clamps on mine. Easy to change when they get corroded. Also you can get green corrosion under the insulation that you might not see. I replaced all the cables in my boat when...
  16. Lou C

    New to Volvo family

    If the gauges have markings on the back you can call Faria tech support & ask. They also repair gauges.
  17. Lou C

    Impeller Question with Rabbit Ears On

    Impeller life seems more a function of the water you’re in, not salt or fresh but shallow/Sandy bottom vs deep water and also care when loading on & off trailer that you don’t tilt too high. I think the longest I went was 5 years. Cobra impeller very easy to do; don’t have to split the drive…it...
  18. Lou C

    Impeller Question with Rabbit Ears On

    Not necessarily The muffs force water in under pressure The true test is if the impeller can move water when the boat is in the water. On mine I usually run the impeller 3 seasons or so. With a 160 stat my running temps are about 160-170.
  19. Lou C

    2000 5.0 GL intermittent slow acceleration

    Are you sure the electric choke is opening & staying open? These need a steady source of 12v to stay open or else they close!
  20. Lou C

    New to Volvo family

    Inspection cameras also help. I feel your pain 22 years of owning & maintaining an I/O. Next boat has to be outboard powered. Expensive but better in a number of ways. Actually if boat companies would make different decisions they wouldn’t be such a nightmare to work on. I changed the rear...
Top