Search results

  1. Scott Danforth

    What is this on my 6cyl in line 165HP?

    No, cooling water drain. you need that item for winterizing to drain the water from the block when the temperatures get to 32 degrees or colder
  2. Scott Danforth

    What is this on my 6cyl in line 165HP?

    looking at the rust streaks, it looks like you have a freeze crack in the block already.
  3. Scott Danforth

    Winterize Tohatsu 50hp 4-stroke on boatport . . .

    It still freezes here in Florida. have had frost in Myakka the last few mornings . There will be a bunch of freeze busted lower units and motors this year. If water freezes in the bird baths, it freezes in the outdrive cavity
  4. Scott Danforth

    VP 5.7 GXI Tachometer Sending unit

    most tachs run off the coil unless they are networked gauges, then they run off the CAN backbone
  5. Scott Danforth

    VP 5.7 GXI Tachometer Sending unit

    the tach is connected to the coil. the ignition firing the coil is what sends the signal to the tach. hint: its the grey wire
  6. Scott Danforth

    Winterize Tohatsu 50hp 4-stroke on boatport . . .

    if the lift doesnt go high enough to get the leg out of the water when the motor is straight down, either remove the boat from the lift, or the motor from the boat. or the lower can bust like this.
  7. Scott Danforth

    Grease Zerk Fitting Question . . .

    rebuilding holley carbs and using a grease gun helping dad
  8. Scott Danforth

    Grease Zerk Fitting Question . . .

    because people like movies, here is a facetube clip on adjusting the end fitting on the gun.
  9. Scott Danforth

    Grease Zerk Fitting Question . . .

    the end fitting on your gun should be adjustable. righty-tighty, lefty-loosy
  10. Scott Danforth

    Thermostat closing position

    all marine thermostats are used as mixing valves and not true shut-off valves. in the outboards, there is constant flow
  11. Scott Danforth

    Wondering how much my latest boat weighs.

    based on the pictures, the boat needs a full cap-off / engine & drive out restoration.
  12. Scott Danforth

    Boat leaking salt water - steering pin?

    based on this pic and some of the others, I would have the boat on the hard, the motor out and be pulling the transom shield
  13. Scott Danforth

    Wondering how much my latest boat weighs.

    No, it will never dry out and be back to usable foam Yes you can remove and replace Go to the stickies at the top of the restoration forum
  14. Scott Danforth

    How bad of an idea is this for OB support while trailering?

    Just like a motor de-flopenizer (AKA transom saver).
  15. Scott Danforth

    How bad of an idea is this for OB support while trailering?

    could always use a motor de-flopenizer (old iboats term)
  16. Scott Danforth

    self leveling or motorized trim tabs

    I would run Bennett sport tabs, All trim manufacturera have sizing recommendations
Top