Search results

  1. dingbat

    Baltimore bridge hit by ship, collapsed

    Pilots are required to be onboard once a vessel enters the mouth of the Bay at Virginia Beach. Have had 3 run aground in the past 15 years and now this. First one cut of the corner at Sharps Island and in bedded itself 40' into the face of the bar a 1/2 mile off course. The last one ran...
  2. dingbat

    Baltimore bridge hit by ship, collapsed

    https://www.cnn.com/us/live-news/baltimore-bridge-collapse-03-26-24-intl-hnk/index.html
  3. dingbat

    Bilge sump question

    Guessing limber holes coming from the front bilge compartment
  4. dingbat

    Mercury outboard power trim won’t work under load

    Are you sure it’s supposed too? Can’t say on smaller units, but on larger units trim and tilt (trailer) are different functions. Tilt function is disabled above X rpm
  5. dingbat

    safety or not safety wise?

    While I’ve had to replace my horn once due to corrosion, I’ve never once actually needed to use it in the 27 years I’ve owned the boat. Having said that, I’ve not heard a horn used in years.
  6. dingbat

    port battery dies when on a charger? Already killed 3 batteries

    Not sure where you’re going with this. Typically the starter cable is connected directly to the battery of thru the battery on/off switch. If the starter(s) is the source of the leak they are shorted internally and must be replaced
  7. dingbat

    Funny things you find when…

    I wasn’t the last person in here……been running like this for 7 years.
  8. dingbat

    port battery dies when on a charger? Already killed 3 batteries

    You have a huge current link which shouldn’t be that hard to find. The usual suspects are starters and bilge pumps. Disconnect the large wire feeding the starters. At battery switch or starter, whichever is easier. Trim the bilge pump(s) off at switch
  9. dingbat

    prop recommendations for Trophy walk around 25 foot

    The motor upgrade was a 275 so you figure somewhere right around 300 hp. Twin 150’s preferred for redundancy.
  10. dingbat

    prop recommendations for Trophy walk around 25 foot

    Kind of irrelevant since he hasn’t been back, but I’m going from a different angle. Something wrong with his prop or engine setup. He’s under powered for a 25’ boat. Found a performance bulletin for his boat with a 300 Hp Verado running a 17”, 3 blade. I’m running basically the same setup on a...
  11. dingbat

    prop recommendations for Trophy walk around 25 foot

    Where did he say this?
  12. dingbat

    Will i need to add a battery switch

    Im running the same setup. Whats confusing? The switch is a simple on/off/combine for use with an ACR There is no need to switch between batteries (battery 1/battery 2) since the ACR handles the charge function. Otherwise, it operates like a normal battery switch
  13. dingbat

    Bunk Boards or Guide Poles?

    The problem you run into with these types of discussions is we’re comparing apples to oranges to pears. What works “best” for a 14’ Jon boat isn’t going to work well for an 28’ offshore boat with a lot deadrise to accommodate. On top of that there are a lot of different bunk designs on the...
  14. dingbat

    Bayliner Trophy Bilge pump question

    Accept the reality that bilge pumps are only there to remove runoff from the deck that accumulates in the bilge and focus on maintaining the systems that account most sinkings….failure to install drain plug, leaking thru-hulls, outdrive boots, and raw water cooling system Personally, I have a...
  15. dingbat

    1990 Evinrude 150hp v6

    OEM Carb kit 0439076
  16. dingbat

    prop recommendations for Trophy walk around 25 foot

    What rpm and speed are you currently running? I’m running a 15 x 15 on a 22’ boat with 225 hp at 5800. Cant imagine running a 17 or 19” prop on a 25’ boat with only 225 HP
  17. dingbat

    Bunk Boards or Guide Poles?

    Guides or poles depends on the trailer configuration. I have a #6000 rated “drive on” bunk trailer. A pair of 3” dia. x 60”, sch. 40 PVC poles line up the boat with the trailer, while keeping the transom centered. The target bunks upfront capture and hold the bow centered to the winch post...
  18. dingbat

    Towing Boston Whaler 130 with Honda CRV

    Mrs. Dingbat was driving a 1200cc 74 Civic hatchback when we met. Struggled with bicycle rack. Couldn’t imagine pulling a trailer with it…..lol Pulling a boat and a horse trailer. Both trailers weight about the same with a single horse in the trailer. Because of the frontal surface area, the...
  19. dingbat

    Towing Boston Whaler 130 with Honda CRV

    OK.......so do I go by GM's recommendation or the recommendation of the manufacturer of my boat trailer? Per (Loadrite) manual I. PROPER TOW BALL HEIGHT Tow ball centerline height should be set between 18” to 21” from the ground for level towing IV. TONGUE WEIGHT All trailers 2,000 lbs. and...
  20. dingbat

    Bayliner Trophy Bilge pump question

    If you read the small print and footnotes on any bilge pump, you'll find that the advertised flow rates are best case scenarios. By the time you figure in actual head, outlet hose size, smooth or corrugated hose, actual supply voltage at pump, etc. you lose up to 30% of rated capacity. So now...
Top