Search results

  1. Lou C

    1989 189 Horizon-where is the fuel tank?

    Lucky to have found one that was stored inside. The kind of construction they used is very rot prone if stored outside. After we re did the deck in mine I threw out all the carpet and had the deck gel coated in non skid gel coat. Sealed all the screws that hold down the seats. And the boat is...
  2. Lou C

    1989 189 Horizon-where is the fuel tank?

    FWs of that era had a hatch over the gas tank screwed down into the mounts for the tank. That stuff on mine was all cheap pine that replaced with mahogany when I redid the deck 15 years ago. Literally 3 of the 4 mounts rotted off. The hatch was just a piece of carpeted plywood.
  3. Lou C

    1989 189 Horizon-where is the fuel tank?

    FWs of that era had a hatch over the gas tank screwed down into the mounts for the tank. That stuff on mine was all cheap pine that replaced with mahogany when I redid the deck 15 years ago. Literally 3 of the 4 mounts rotted off.
  4. Lou C

    Mercruiser - 3.7 ( 470 ) Alpha1 ( please list the sources of CLEAN water in the oil ) about a cup - Antifreeze not leaking - no green in the water -

    That’s what I was trying to say!
  5. Lou C

    Mercruiser - 3.7 ( 470 ) Alpha1 ( please list the sources of CLEAN water in the oil ) about a cup - Antifreeze not leaking - no green in the water -

    But the water that exits the Heat Exchanger has to be sent thru the elbow to exit over board, correct? If there is a rusted thru area then the water can get into the exhaust gas passage & then into the cylinders/motor oil.
  6. Lou C

    1988 Bayliner Capri with a 2.3L OMC Ford cobra

    Ok yeah one less thing to go wrong! Boats this age often need the helm unit & cable replaced just due to wear. 30+ years is a long time!
  7. Lou C

    Mercruiser - 3.7 ( 470 ) Alpha1 ( please list the sources of CLEAN water in the oil ) about a cup - Antifreeze not leaking - no green in the water -

    Even though you have closed cooling your exhaust elbow is still raw water cooled, correct? This could be leaking at the gasket between the manifold & elbow or via a hole in the elbow to from the water side to the exhaust side.
  8. Lou C

    1988 Bayliner Capri with a 2.3L OMC Ford cobra

    Not knowing what is in there, hard to say, but I always used Dex from the auto parts store I had to change that P/S actuator a few years ago, made a mess while it was leaking for a couple seasons. Removed the exhaust on both sides for access and had to get this cotter pin removal tool to get...
  9. Lou C

    1988 Bayliner Capri with a 2.3L OMC Ford cobra

    OMC used Dexron in the power steering & tilt n trim
  10. Lou C

    OMC cobra 5.0 efi surging in idle

    Manual = real learning
  11. Lou C

    2015 Motor MerCruiser 4.5L 250hp NO EC - OVERHEATING!

    Although here in coastal NY Yamaha is everywhere
  12. Lou C

    1988 four Winn horizon 200

    The other thing I wanted to mention is that when I replaced the deck I had the 'glass shop gel coat it in non-skid gelcoat, I did NOT want carpet on a wood cored deck, sealed all the holes to mount seats. IMO carpet is death to wood cored decks, all it does is hold moisture, that rots wood. And...
  13. Lou C

    Sound deadening

    In a boat nothing sounds better than a V8. Yesterday I was out on the bay and heard the howl of a go-fast going & coming while I was out.
  14. Lou C

    1988 four Winn horizon 200

    OMC did use the Ford small block with the Cobras but the bell housing & engine mounts are both different. At this point you have to decide if you want to switch the whole thing over to Mercruiser. If you get the right deal on a drop in it’s the way to go. I like the Cobra it’s been very good to...
  15. Lou C

    Sound deadening

    Or…eventually repower to a V8 then you won’t want to muffle it!
  16. Lou C

    2015 Motor MerCruiser 4.5L 250hp NO EC - OVERHEATING!

    Most common appear to be Mercury & Yamaha although Suzuki is gaining ground. See what’s most common in your area…
  17. Lou C

    1988 four Winn horizon 200

    Most of those boats came with either a 4.3 V6 or the 5.0 V8. I would stick with Chevrolet power whether you keep the Cobra drive train or convert to Mercruiser which will make your life easier. You’d need a post 1986 SBC, one piece rear main seal, could be pre-Vortec or Vortec. I have the 4.3...
  18. Lou C

    1989 Bayliner Trophy OMC 5.8L - Help with new boat

    Yep that sounds like what happened. Once you get it set up right it's not hard to keep it shifting well. Starting with a new cable, cleaned out pivot housing, all adjustments done you should be good. With all the bad press OMC got on these I am amazed at how reliable this boat has been. And...
  19. Lou C

    1988 four Winn horizon 200

    Yes check very carefully for rot, especially if it had plywood decks covered in carpet. Mine had the deck replaced in 2007, outside painted in Imron 2012 and top end engine overhaul in 2017. It's a good running stable boat, I will gladly repower it when the time comes.
  20. Lou C

    1988 four Winn horizon 200

Top