Search results

  1. Bondo

    5.7 ENGINE OIL PAN

    Ayuh,..... Hope the new pan has inch threads, 'n not metric,....
  2. Bondo

    Trim/tilt rams: delete?

    Ayuh,....... Welcome Aboard,....... How did ya come to that conclusion,..??..??
  3. Bondo

    5.7 ENGINE OIL PAN

    Ayuh,..... Marine, truck, 'n car, are all the same blocks,..... Some marine oil pans have the dipstick mounted in the pan,........ some don't,....... Trucks, 'n cars might use the same exact pan,..... others don't,..... The pickup/ car dipstick might interfere with the exhaust...
  4. Bondo

    5.7 ENGINE OIL PAN

    Ayuh,..... So long as ya got the dipstick figured out, go ahead, 'n use what ya got,.....
  5. Bondo

    5.7 ENGINE OIL PAN

    Ayuh,..... Welcome Aboard,..... Why are you goin' backwards,..?? Yer gonna have more issues than just the oil pan not fitting,.... The flywheel, 'n coupler are also different,..... The 1-pc. seal crankshaft is a 3" bolt pattern, 'n the 2-pc crank pattern is 3, 1/4",.....
  6. Bondo

    Side to Side play on wheel

    Ayuh,..... It takes 3 folks to check to see exactly where such slop is,.... One to hold/ shake the steerin' wheel,..... One to hold/ shake the outdrive,..... 'n the 3rd to look at All the connections to see exactly where the wear is,.....
  7. Bondo

    The hoses from HELL

    Ayuh,..... I've got a Snap-on set like those,..... If you can get the swing, they oughta work,.....
  8. Bondo

    5.0 Volvo Penta - Not going full speed at full throttle

    Ayuh,..... Welcome Aboard,..... Pull the fuel filter, 'n dump it into a clear container to see how much crap is in it,.... Then put on a new one, 'n try it,....
  9. Bondo

    Severe backfire

    Ayuh,.... Have you don't any testin',..?? Set the timing,..?? What motor,..??
  10. Bondo

    Mercruiser 4.3 EFI water intrusion issues

    Ayuh,..... Welcome Aboard,.... Has the motor been run, since the incident,..?? If not, do it,... Right now,... Gotta burn out the saltwater,.... I don't buy the tuliped valve theory as the cause,.... not sayin' it don't have a bad valve, but it ain't the cause,..... I would drain...
  11. Bondo

    1988 4.3 ltr engine starter wiring

    Ayuh,..... The big battery cable, the orange from the alternator, 'n the wire to the circuit breaker all go to the big post,..... The yellow/ red wire goes to the small post nearest the block,..... There should be a purple/ yellow wire on the other small post, away from the motor's block,....
  12. Bondo

    1993 Johnson 150 Ocean Runner broken steering arm

    Ayuh,..... How are you gonna run it, if ya can't steer it,..?? If you use the busted steerin' arm(Tiller), 'n it breaks off,..... The motor will swing to a full lock turn, probably throwin' people outa the boat,.....
  13. Bondo

    Thud noise when trimming prop down under load

    Ayuh,..... The in/ out movement is normal,..... As for the clunk,.... Trim full down, before you slam the throttle,..... 'n donno why you posted twice, 2 hours apart, but I'll delete the duplicate,...
  14. Bondo

    Pedestal Seat Base

    Ayuh,..... Use a hole saw to cut a hole dead center of the base, just big enough to get yer hand in there,.... Once the seat is mounted, the hole disappears,.....
  15. Bondo

    5.0gi PEFS Throttle body torque specs

    Ayuh,..... I don't torque wrench 'em,.... Just run 'em down, good, 'n snug,.... Probably 15, maybe 20 ft.lbs. from my calibrated elbow,.....
  16. Bondo

    1996 Bravo 3 Aluminum ring for u-joint bellows

    Ayuh,..... Get a can of Quicksilver Power Tune, 'n squirt abit on the rubber,.... The ring will go in, Much Easier,.....
  17. Bondo

    sudden grinding noise then stallked.

    Ayuh,.... Sounds like catastrophic failure,.... The motor turns clockwise viewed from the bow, 'n yes, the flywheel should turn with the crankshaft,.... Is there any oil in the motor,..??
  18. Bondo

    What type/size of boat to get for the St. Lawerence river?

    Ayuh,.... The longer the boat, the better the ride,....
  19. Bondo

    Trim up not working.

    Ayuh,.... The usual problem is the wires, not the sender, or switch,....
  20. Bondo

    Water in cylinders after sitting

    Ayuh,..... If you don't find joy there,.... Drain the water from the block, isolate it, 'n pressure test it with 'bout 15 psi of air, 'n listen,..... Then follow the sound to the leak,.....
Top