Search results

  1. alldodge

    Gun Range Vid sort of

    I'm thinking along the line of a camera set up close by the target and a receiver display at the bench
  2. alldodge

    Gun Range Vid sort of

    Issue Picked up a Bushnell X65 spotting scope and i works but talk about vibration issues. Does not take anything to move the scope and mess up the view a 100+ yards Looking into cameras to show real time shots but that to has issues Anyone have history of things that work?
  3. alldodge

    Alpha one Gen one Sterndrive

    Check your idle RPM should be no more the 700
  4. alldodge

    3.0L cooling hose discontinued?

    Yes, standard heat hose will work so long as it's not a suction line. If you have a Alpha drive then none of the hoses are suction
  5. alldodge

    2000 Volvo Penta 5.7 Gfi with no spark

    Then the fuel pump circuit of the ECM works
  6. alldodge

    Bravo 3 hiccups

    Welcome and sorry no one responded This normally happens when the clutch shaft gets glazed. The fix to to replace the shaft and in many cases also the gears. To find out which parts will be needed it would be necessary to know your drives serial number. So far as the boat listing to port that...
  7. alldodge

    Water in fuel

    Stabil is to keep old gas sort of new while setting over the winter, it won't make bad gas good Try it, if motor runs ok then your good, if it doesn't then it all has to come out and need to empty filter and carb again
  8. alldodge

    Volvo Penta exhaust riser

    I think that would be ok, but I asked Scott because he is more up to date with VP stuff
  9. alldodge

    Trim guage dash question

    Don't know but most all gauges work the same so it should work. To only issue might be is if Yam is different then any other On the other side; if you have not drilled the hole yet (doesn't look like you have) and if there is room. Drill from the back side 1/2 way thru or so and stop with a...
  10. alldodge

    Volvo Penta exhaust riser

    I think that is used for salt away sort of thing. Hey @Scott Danforth what do you think?
  11. alldodge

    1997 merc 225 efi injectors

    All Merc injectors are turned ON by the ECM applying a ground. If no ground is being applied then there will be 12V passing thru the injector coil and will read on both sides. The issue I have with your statement, is "normally" you will not see 12V with key OFF Going to move your thread to OB...
  12. alldodge

    Volvo Penta exhaust riser

    Welcome Post a pic?
  13. alldodge

    454 vibrating and breaking starter bolts

    Think I found it, can tell from the balancer https://www.chevelles.com/threads/how-do-you-tell-a-402-bbc-from-a-454.71177/
  14. alldodge

    5.0xl/V8 mer. Where do I start?

    Your serial number shows a mechanical fuel pump, so if it's not pumping then need to get another one
  15. alldodge

    2000 Volvo Penta 5.7 Gfi with no spark

    ok, it's a Gi The power to the coil comes from pin J2-32 (pink/white) on the ECM If your not getting 12V at the coil then might need to get ECM tested Best thing would be to check for codes and also check all fuses To check for codes using a 12V resistor led or a digital meter with tone Find...
  16. alldodge

    5.0xl/V8 mer. Where do I start?

    Do you see fuel squirt down throat of carb when it's pumped? Might need to fill the filter to help get all the air out
  17. alldodge

    2000 Volvo Penta 5.7 Gfi with no spark

    Going to need more info. The place I use to go to find parts break down is gone. I'm unable to find a Gfi but am able to find Gi
  18. alldodge

    Volvo Penta D3-200 Turbo

    Welcome Have not worked on the 200, but like all marine stuff ya just need to figure out what needs to be removed to get at what you want to take off, Sometimes you need to make a tool. Example: There was one bolt I could just barely get at on starter for a D3 dozer. Bent a boxed end just...
  19. alldodge

    Messed up or no?

    Welcome Changed your title That's just Gelcoat, can be redone or sanded and painted
  20. alldodge

    Did I just mess up my pontoons?

    Wonder if your toons were clear coated? If so that damaged the paint
Top