Search results

  1. Bondo

    2.00 ratio Alpha one gen 2

    Nope,...... Not at All right,.... Quite the opposite,...... Unit, for unit, they'll swap just fine,..... Guts to a different case is called a Rebuild, with all the sequences to get there,.....
  2. Bondo

    Gimbal Housing Anode Bolt Torque Check

    Ayuh,...... Welcome Aboard,...... Unfortunately,... If those bottom bolts are loose,...... You've got a rotten transom, 'n those bolts are about to break,.....
  3. Bondo

    Raw water flow

    Ayuh,..... There's an idle relief port on each side,...... Don't drill anything, but you can poke around it abit,..... Ya might find an ole shutter bit in there,.... Any exhaust or water not comin' outa those ports is expelled through the prop anyways,....
  4. Bondo

    84 searay Seville 2.5 omc stern drive removal

    Ayuh,.... Welcome Aboard,...... I see it's OMC powered,... an '84 will be a stringer drive,..... Not the best choice of boat to dump any money into,.....
  5. Bondo

    Tracking down and repairing leak in aluminum hull (starcraft islander)

    Ayuh,..... Dead center, is the drive shaft,..... So what are you calling exact middle,..??
  6. Bondo

    Volvo AQ225 dipstick crossover

    Ayuh,..... Welcome Aboard,.... The odds of a truck dipstick bein' right, is pretty slim,.... If you can find one that's to long, it could be modified to work,..... I've had good luck, repurposing ole speedo cable, into a dipstick,..... The drawback is findin' the new proper level mark,....
  7. Bondo

    Bell Housing - Merc 250 vs 292

    Ayuh,..... That's why Chevys run one of 2 starters,..... The staggered bolt pattern like yers, 'n the straight across for the small flywheel,..... Is yer block drilled for both starters,..?? If not, you need to find a MC-1 bellhousin'/ flywheel cover for the big flywheel,.... It can be from...
  8. Bondo

    Does my engine work or my upper is broken

    Ayuh,...... Is yer's the 12- point heads,..??..?? 12 - point socket, 3/8" I think,.... or the allen heads,..??..?? An allen drive key, or socket driver,.... Was there any metal in the oil ya drained outa the drive,..??
  9. Bondo

    hooking up 4stroke kicker to existing fuel tank (starcraft islander)

    Ayuh,..... You shouldn't need a regulator, at All,....... I'd run it, from the tank, to the valve Redrig posted, to the canister filter, out one port to the existin' fuel pump, 'n out the other port, to the outboard,..... Get ridda the in-line filter, 'n the regulator,....
  10. Bondo

    4.3 merc water in #5 cylinder

    Ayuh,..... If the manifold/ riser joint gasket fails, in leaks into the downhill cylinder,......
  11. Bondo

    How does the Mercruiser Shift Switch work?

    Ayuh,..... 'n Only when the boat is In the water,..... not ever when on the wagon,.....
  12. Bondo

    Does my engine work or my upper is broken

    Ayuh,..... It's really hard to see, but are there splines, inside the coupler in the 1st video,..?? If the splines in the coupler are wiped out, That's yer problem,..... Whatcha workin' on,..??
  13. Bondo

    Tracking down and repairing leak in aluminum hull (starcraft islander)

    Ayuh,...... In my mind, that's the worst test there is,..... Water gets real heavy, way before the outside waterline when the boat is floatin',...... What I always did was launch it, tie up, 'n go crawlin' through the bilges cavities,..... Look under, 'n behind everything,..... A good...
  14. Bondo

    Trim ram maxium extension

    Ayuh,.... Especially with a big swim platform,.....
  15. Bondo

    4.1 mercruiser

    Ayuh,..... Welcome Aboard,..... There should be a welch plug in that hole, to seal it water tight,...... That's the shift linkage pocket, that has to be dry,.....
  16. Bondo

    Trim ram maxium extension

    Ayuh,..... Welcome Aboard,...... That sounds like it might be at the Trim limit,..... There oughta be an over-ride switch to engage the Tilt,.....
  17. Bondo

    Tracking down and repairing leak in aluminum hull (starcraft islander)

    Ayuh,.... Where, Exactly did you find the leaks,..?? As Scott alludes too,.... There really ain't anything that fixes leaks when smeared on the outside,..... Some sealants, like 5200 might help,... or not,.... Generally speakin' ya remove whatevers in yer way, 'n work from the inside for...
  18. Bondo

    Terry bass boat

    Ayuh,..... Welcome Aboard,..... Yer pictures Suck,.... Yer not showin' what yer askin' about,.....
  19. Bondo

    Sea King Montgomery Ward motor info

    Ayuh,..... Welcome Aboard,...... Even if they run, they ain't worth squat,.....
  20. Bondo

    Restoring a chaparral 187XL

    Ayuh,..... Sounds like ya got the hard part done,.... so why not,..??
Top