Search results

  1. alldodge

    DPS Lower Water Leak and Prop Shaft Play

    I was able to look up the parts breakdown in link below but still not able to find service manual. Hope Muc can assist https://www.volvopentastore.com/
  2. alldodge

    DPS Lower Water Leak and Prop Shaft Play

    Hey @muc can you assist?
  3. alldodge

    DPS Lower Water Leak and Prop Shaft Play

    This is where I would go, they want the serial number or product number https://www.volvopenta.com/en-us/service-and-support/your-engine/manuals-and-handbooks/
  4. alldodge

    DPS Lower Water Leak and Prop Shaft Play

    Welcome Looking at the vid it appears there was water or some other liquid inside the drive. If that is correct then pressure test is done incorrect, should be dry and only with air. Pressure should be no higher then 10 psi and lower is better Need to start with the manual for the drive...
  5. alldodge

    Texas Trailer Registration Help!

    Welcome Not from TX but I find need form VTR-141 is used for homemade https://www.txdmv.gov/sites/default/files/form_files/VTR-141.pdf TxDMV states Note: A manufactured trailer with missing paperwork cannot be registered as a homemade trailer. Here is the link for assembled trailers...
  6. alldodge

    2013 Mercruiser 3.0 MPI (engine rebuild)

    Yes heads and block are the same
  7. alldodge

    Trim limit switch

    ^^^ Agree, it's not needed
  8. alldodge

    Boat wont start

    Don't have a wiring diagram for your motor. I do have a service bulletin for the PCM09, yours being a 2010 it may have this, need serial number to verify. The SB does list pin out
  9. alldodge

    Boat wont start

    Key turns ON no beeps but gauges turn on This means power is making it to the key and heads back to motor but ECM is not being turned ON, or as listed voltage is low so ECM will not fully power up. There are at least 3 fuses and 2 to 3 relays on top the motor. The relays are the same and...
  10. alldodge

    Boat wont start

    Measuring voltage at the starter post, what is the reading when key is turned to start? Do you get 2 beeps when key is turned to ON?
  11. alldodge

    Fuel Pump Wiring

    1. Remove the sender in pic 4 and install a brass Tee. Reinstall sender on one side of brass Tee. Other side of Tee install new oil pressure switch 2. Scott has link to switch 3. Yes, the purple wire must be mounted on the coil + side Note you must have a small post on the outside furthest...
  12. alldodge

    Fuel Pump Wiring

    Sorry Scott I retract the switch will work
  13. alldodge

    Fuel Pump Wiring

    Your pic 4 is the oil gauge sender and does not have anything to do with the fuel pump Thanks for the serial number. Your motor came with a mechanical fuel pump. The electric pump was added later. The pump was mounted on the raw water pump, item 1...
  14. alldodge

    6 year anniversary of quitting smoking, yay me!!!

    Have one kid and one grand kid that vap's, wish they would quit but would rather see them smoke then vap
  15. alldodge

    Mercruiser - Stalls in Reverse

    Didn't notice you said this prior but the drive has to be down. Trying to do it with the drive up put stresses in areas that would not normally be found while running
  16. alldodge

    Mercruiser - Stalls in Reverse

    That should not happen The shift interrupter should "only" activate when in gear (F or R) and under load (in the water) when shifting into neutral
  17. alldodge

    Mercruiser - Stalls in Reverse

    The shift assist should not even function (no movement) on muffs because there is no load
  18. alldodge

    Fiber Optic Connector Width for Drill Size

    Look forward to hearing this as well My buddy had fiber installed in hi log cabin a couple years ago, I'm still waiting. He said they wanted the box mounted to be just inside where the cable comes in. I didn't ask him what size holes as he didn't drill. It was my understanding as the cable...
  19. alldodge

    2008 Rinker 296 Bowrider Vent Cover

    Rinker is out of business Woops was OoB looks like covid didn't take em out Double woops, had it right the first time. Polaris bought Rinker and stopped making boats
  20. alldodge

    Dieseling after shut off and loud noise when trim is higher in shallow water

    I wasn't thinking you ran the drive out of the water, just maybe it's coming up higher then it should. The trim limit switch on the drive should be adjusted so it only has maybe 30 sum degrees total movement. Meaning from tucked in to trim up. It should then stop moving and only way to get it...
Top