Search results

  1. alldodge

    Optimax 115 2005 flywheel nut size?

    Best to use serial number to look parts up I'm seeing a 17MM but this may not be yours https://www.mercruiserparts.com/bam/subassembly/32196/10131/30
  2. alldodge

    Mercury Binnacle remote control - Gen 1 vs Gen 2. Worth the upgrade?

    Opinion: Had the top pic installed on my 95 Formula and never had an issue with it, it's well made. Did replace the trim switch a few years ago
  3. alldodge

    1995 Regal Commodore 272 dip switch panel replacement

    Ya got your question narrowed down to only folks with same model. Might post a pic so folks can see what your trying to replace
  4. alldodge

    Fuel dumping in 5.0 cobra 1994 mechanical pump, not electric.

    Don't change plug heat range nor gap. Increasing gap will cause fuel to burn faster. If it burns faster then preignition can happen. Preignition will destroy your motor pretty quick
  5. alldodge

    Mystery Knock -- Insurance and Warrantee

    Cut the oil filter open and see if you can find any metal
  6. alldodge

    4.3 Mercruiser fuel supply issue

    Removing the drive is easy for the most part With a Alpha drive move throttle full forward (don't use throttle only it needs to be in forward) Trim drive so it's straight up and down Remove pin from rear trim cylinders Remove six bolts holding drive and then slide drive out Might need a block...
  7. alldodge

    4.3 Mercruiser fuel supply issue

    Your say "inboard" but thought you had a I/O If it's a I/O then remove the drive before jacking up motor If inboard, remove prop shaft coupling before jacking motor
  8. alldodge

    4.3 Mercruiser fuel supply issue

    Understand, sometimes it's just to much for me also. If there is room, small bottle jack to lift that side of the motor just enough to remove the the motor mount. Or if you have a hoist
  9. alldodge

    snapped driveshaft Mercury 2011 150 Optimax

    The coming out of the water is what's doing it. The offshore racers has a dedicated throttle man, he pulls the throttles back every time a prop rev's increase above spec. Even those guys will break things when the props rev up and then hit the water again
  10. alldodge

    Mercruiser 5.7 MCM carb low idling

    This should not happen. The temp switch should stay closed and pass current when motor is OFF. The current only stops flowing when the motor cools down.
  11. alldodge

    Anyone have mer control pdf

    Look here https://www.mercruiserparts.com/remote-controls-and-components
  12. alldodge

    Overheating

    Retact, yes it did say "carburated 1999 5.0 mercruiser alpha1 gen 2." but should not have had 2 post in same section
  13. alldodge

    Overheating

    No, it did not have the info, I deleted it and MOD's can still see it. Pull the lower and check the impeller
  14. alldodge

    Overheating

    Need more info???????????? What motor ??? Is it a Alpha Gen 1 or 2, or even a Bravo???? With a oil cooler it's most likely a Bravo and maybe a BB
  15. alldodge

    idle adjustment screw

    Depends which carb and which 4.3 LX, several have been made of different designs The idle adjust is located on the same piece that the throttle linkage is attached to. Should be below it
  16. alldodge

    2007 Merc 5.0 TKS stalled at speed, had to be towed

    Yes, + and - Meter TKS Module Resistance Ambient temperature 21° C (70° F) 35-45 Ohms - -6.6 ° C (20° F) 55-70 Ohms
  17. alldodge

    Mystery Knock -- Insurance and Warrantee

    The oil temp will always be hotter then water temp. So long as temp stays below 300* it won't burn and still lubricate Most small block won't have a oil cooler on them and big blocks do. My 530hp showed water temps was normal but after installing a oil temp gauge, found oil was over 300* when...
  18. alldodge

    snapped driveshaft Mercury 2011 150 Optimax

    What was the boat doing when it happened? If the prop came out of the water and rev'ed high it will break things when it comes back in the water
  19. alldodge

    5.0 OSi-JF overheating at speed

    Hey @kenny nunez or @Scott Danforth
  20. alldodge

    2007 Merc 5.0 TKS stalled at speed, had to be towed

    I doubt it because you said the diode was overheating (Post 2 pic). If it was shorted out you wouldn't be able to turn the motor off. Blowing the fuse and diode getting hot leads me to the TKS module
Top