Search results

  1. C

    1994 bayliner trophy 24 foot walkaround

    Washing down a boat counts as filling up the bilge.
  2. C

    1994 bayliner trophy 24 foot walkaround

    A friend had a older boat that would leak in water while docked. Pump would not tun on when it should have. Water built up. Then when was started. The float popped up and drained the bilge perfectly. We repaired the problem.
  3. C

    1994 bayliner trophy 24 foot walkaround

    The picture should help. (y) How were the underwater Scuppers sealed up or replaced with epoxy plates on the outside of the transom surface.
  4. C

    1994 bayliner trophy 24 foot walkaround

    Friend almost lost his brand new boat when the very low scuppers suddenly leakedin water. Zebra Mussels started to build up an hold open the lowest drain out Scupper flap. That became a common problem on New Trophy boats.
  5. C

    1994 bayliner trophy 24 foot walkaround

    Yes it is a O B boat. So back to the weights of each motor ?
  6. C

    1994 bayliner trophy 24 foot walkaround

    Found a detailed description of yours. Interesting fact is it has deck scuppers. Does your bilge sump pump, empty the bilge completely ?
  7. C

    1994 bayliner trophy 24 foot walkaround

    Had to look your boat up They are inboards.
  8. C

    What Thrust Size Trolling Motor?

    Are you serious ? Or just wanting to talk ?
  9. C

    Starter issue 1990 E'rude 8 hp.

    Buy and install a 3 pole roller micro switch. Where the shift lever linkage passes near the engine block somewhere. My 1986 30 hp motor. DO NOT drill into a water passage. IF you do ? Drill and tap the 2 holes. Dry the holes. Coat the screws threads with some Silicone Rubber. will last over...
  10. C

    Boat budget question

    You are now a senior aware of life. (y)
  11. C

    1995 Force 120 will no longer idle

    Fuel pump is dying. It will keep getting worse. Then die totally. Been there. I rowed about 1 mile. I bought a pump repair kit by Evinrude. Opened the fuel pump over a white towel. Took kit and towel to my Evinrude dealer. Way to many parts and instructions.
  12. C

    Stik-It Anchor pin mount

    Put that in the bow of the boat. If a V hull ? It will hold much better.
  13. C

    Picked up a 1990 Force 50HP yesterday.

    I can not pick up a 30 hp anymore. :)
  14. C

    making your own gaskets / seals

    That is a very difficult one to do. Buy a correct one for the trip.
  15. C

    Water in bilge

    I tolerate 0 amount of leaks into the bilge area. Leaks usually get worse. Suddenly
  16. C

    Loud Rattle On Startup

    Sounds like a bearing.
  17. C

    End of Season oil changes?

    Post # 4 is the most correct answer and reasons to change ...BOTH. Go for it. (y)(y)(y)(y)
  18. C

    Transon mounted trolling motor

    Remember. That a vest of any type almost stops any type of swimming speed. And allows the wind to push you around.
  19. C

    New Stuff on Vehicles likes/dislikes

    Had a date like that. :)
Top