Search results

  1. alldodge

    Boat won’t shut off

    Motor not shutting off may be a bad key switch or other. With voltmeter check for power on the purple wire with key off. If you have power with it off then disconnect purple wire and see if it goes dead. If it does not go dead look for something miswired
  2. alldodge

    Boat won’t shut off

    Those wires have been added and are small so they probably go to something that was added like GPS, fish finder, etc Thanks you have EST dizzy
  3. alldodge

    Boat won’t shut off

    Which distributor does it have? DDIS or EST EST resembles a standard cap, the DDIS does not
  4. alldodge

    Boat won’t shut off

    What year is the 3.0 never mind its a 94
  5. alldodge

    Boat won’t shut off

    I'm merging both your topics and putting them in the Merc section
  6. alldodge

    Rudder Stiff and Hard to Turn Problem

    That would be my guess also. Disconnect the tie bar and see if it's one or both
  7. alldodge

    Boat won’t shut off

    Actually there should not be a orange wire under the helm. If it is coming from ALT it probably is hot all the time. The hot wire going to the key switch should be Red/Purple
  8. alldodge

    please help timing issue is the expected issue help!

    ok, we need to know what your working on. It's a 1999 GM 5.7 what? GL, GI, GXI something
  9. alldodge

    Mercury Scorpion 350 Will not start

    Do you hear any beeps when key is turned ON?
  10. alldodge

    Mercury Scorpion 350 Will not start

    Tune up done and now it will crank but not start, did someone happen to trip the kill switch?
  11. alldodge

    1988 StarCraft Select 191s wiring question

    Welcome Only a person with the exact boat might be able to answer the question. Just trace the wires or remove both ends from the breaker and connect together. Then see what works
  12. alldodge

    Mercruiser 5.0/Chevy 305 firing every other cylinder

    Pull plugs and compare plugs, all should look the same. If they do it could be it's probably the idle circuit in the carb.
  13. alldodge

    5.7 GXI-H engine. Alternator problem ?

    Every belt has a means of adjusting the tension. Can be a unit like the ALT or a idler pully
  14. alldodge

    Gauge Identification / Testing / Replacement

    Correct Correct This is the unknown I have not seen where "these gauges" use the North American standard but do "think" they do. The standard is 30 ohms to 240 [edit mistake in range]
  15. alldodge

    Gauge Identification / Testing / Replacement

    805218T is the Temp switch and not for a gauge 806490T is for Water Temp gauge 8M0068764 is for oil pressure gauge
  16. alldodge

    Changing my boat gauges.

    All Iboaters will be here to help, just may not be quick responses, but we will be back
  17. alldodge

    Transom leak near exhaust

    What I think you have is a soft transom. Once the transom gets soft it has to be replaced. If it's not the transom it could be the exhaust Y pipe but the motor needs to be pulled to get in close enough to inspect. Might get a bore scope phone attachment so you can get in closer, but still...
  18. alldodge

    Maybe my turn for new boat time

    17 hours and opened it up for another short bit and got 57 MPH (y)
Top