Search results

  1. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    It's very rare to have a coil go bad. Folks replace them all the time with no change With rpm's all over the place maybe the Tach is an issue. Disconnect the gray wire on back of Tach
  2. alldodge

    Detailed wiring schematic for 43GL-PEFS

    I don't have a pefs but this is for the GL fuel pump. In most cases the diodes are next to the relay
  3. alldodge

    Detailed wiring schematic for 43GL-PEFS

    Yes, you are correct
  4. alldodge

    New 5.7 runs and shuts off

    You can do that, but could be the Reg you have is not set at 30. Installing another Reg to control the first just means more issues, but it's your boat
  5. alldodge

    Mercruiser 383 Mag Stroker MPFI Bogs Over 3000 rpm

    Thanks even-rude for closing the issue
  6. alldodge

    New 5.7 runs and shuts off

    The Reg screen, but you said it's new and came with new Reg Partial collapsed fuel return line There is a Reg in the TB but that should have no effect on pressure because if Reg releases any pressure it has no place to go. Most TB Reg's are just to dampen fuel pump pulses Only other thing is...
  7. alldodge

    Bravo 1 low water pressure

    I'm not seeing any issue with water flow. Hope someday someone will come up with a fix to fake the sensor to the ECM
  8. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Looks like Horigan was leading you in the right direction Without checking for codes we're guessing The oil and temp switches should be able to be un-plugged. If on of them is grounding out (telling ECM to SLOW) this will show all good to ECM
  9. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Well, looks like the parts manual shows different https://www.volvopentastore.com/Marine-Gasoline-Engines-for-5-0FIPNCACE-5-0FIPNCBCE-5-0FIPNCMCE-5-0FIPNCSCE-5-0FLPNCA-5-0FLPNCB-5-0FLPNCM-5-0FLPNCS-7797220/dm/cart_id.456747459--session_id.325411975--store_id.366--view_id.765138 If you look at...
  10. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    With other running fine off same gas then look at the carb, probably clogged up a bit
  11. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Adding good gas to bad gas just makes more bad gas. If it is bad it needs to be drained and maybe used in a lawn more if it's not to terrible Take the filter off and pour contents into a clear container. The gas should be crystal clear and not smell like anything other then gas
  12. alldodge

    Volvo Penta 5.0FIPNCSCE SLOW mode

    Welcome Your motor has a ignition module but not a ECM, has carb. Don't see it going into any kind of safe mode, but may retired timing "if" it has a knock sensor. Don't see a knock sensor with the brief look over the parts My guess is you have a fuel issue, and once fuel goes bad it cannot...
  13. alldodge

    2010 350 Mag MPI bravo 3 gaurdian mode issue. 5% power

    Unsure about exhaust co but would lead me toward the exhaust O2 sensors. Being it happens at 3000 rpm try disconnecting the in-gear switch on the shift plate. Probably won't change anything but it also won't hurt anything.
  14. alldodge

    1966 sears rivets leaking

    I think 3M5200 would be great for the task
  15. alldodge

    New 5.7 runs and shuts off

    Sorry didn't realize you posted requesting the part number. I merged the threads to keep them together Part number is 807952A1 That said I'm using 1999 to 2001 TBI because I don't have your serial number. Might have missed it
  16. alldodge

    Detailed wiring schematic for 43GL-PEFS

    There are 2 diodes going to the relay coil side, and if the one on the ALT side shorts it will keep the relay pulled in. Your pump is running without the relay installed so there is a short or PO rewired it direct because they may have had the diode open
  17. alldodge

    350 Mag Mpi hard to start when warm or hot

    Check resistance of ECT cold and hot Changing more parts can induce more issues As the throttle increases further does the voltage start to increase then, or still lower? Your sensor is a MAP and TMAP, so it measures pressure and Temp. As Temp rises ohms lower
  18. alldodge

    Mercuiser 357 mag low compression on #6 (120 psi)

    Ron White I'm out
  19. alldodge

    New 5.7 runs and shuts off

    Not likely and as before it wouldn't matter if Reg was set to limit at 30
  20. alldodge

    Mercuiser 357 mag low compression on #6 (120 psi)

    Compression ratio is compression ratio Math does not lie, incorrect calculations can If atmospheric pressure is used, turbo changed, supercharged the formula is correct. The DF300AP list 123 to 213 psi which leads me to think this covers more then just the 300, as with the older Verado V6 OB...
Top