Search results

  1. 9

    Trim Function for Yamaha 90 Four Stroke

    you do not even know how many relays this T&T system has , so you ask that question after he has tried running the T&T motor directly to the battery. And checking grounds too when the wires are tried directly to a battery maybe you should be looking up and reading some before throwing stuff...
  2. 9

    Trim Function for Yamaha 90 Four Stroke

    I asked if he took the motor wires off the relay and put directly on the battery, and he said he did. did you read what was written in the thread before responding to it?
  3. 9

    Trim Function for Yamaha 90 Four Stroke

    so a bad ground would still affect the motor when both leads are jumped straight to the battery? how does that happen
  4. 9

    Trim Function for Yamaha 90 Four Stroke

    what does this have to do with the motor that will not turn when jumped directly to the battery?
  5. 9

    Trim Function for Yamaha 90 Four Stroke

    did you remove the motor wires from the T&T relay and then jump those to a battery? if so yes that motor is bad. look up you motors T&T motor part number and then do a web search to find lots of places to buy them, and also some aftermarket ones
  6. 9

    Trim Function for Yamaha 90 Four Stroke

    how did you jump the T&T motor? you need to provide both + and - for the motor to run
  7. 9

    Suzuki DF250APX knocking noise

    buying a motor with a problem is not a good idea. guessing at what is wrong with it and hoping it is a easy cheap fix is not good either. have them fix the problem before you buy it
  8. 9

    Aggravating gasket

    I have reused them many times before as long as they are not swollen/ out of shape when removed. e fuel does mess with them some times. there should not fuel high enough in the bowl to be in contact with them under normal running conditions. maybe when tilted up the fuel would come into...
  9. 9

    Engine flushing 150 yamaha

    just to let you know a muffler is something on a motor to quiet the exhaust out of a motor. muffs are for flushing an outboard that you attach to a lower unit on the water intake area. maybe Brits and Canada people call them mufflers for some reason. I am not sure if you are running the motor...
  10. 9

    TPS

    did you try brownspoint.com?
  11. 9

    Suzuki DT40 - not pumping water

  12. 9

    Suzuki 250AP trim switch question

    remove the hot wire. that should disable that switch
  13. 9

    Yamaha 01 250 OX66 running rough. Trying to figure it out.

    spark plugs maybe
  14. 9

    Yamaha problem

    have you tried pumping the primer bulb to see if the fuel bowls are full when this is happening? I guess this is a 2 stroke since you did not say it is a F50 I know this does not make much sense, but my BIL's 50 would bog down and die then giving it throttle and all I found wrong was some...
  15. 9

    Question about LU rebuild + getting ripped off on sale.

    or they tried pumping gear lub in without removing the top screw. causing pressure to build up inside and popping the seal out
  16. 9

    Question about LU rebuild + getting ripped off on sale.

    most people make it easy and post what motor they are taking about when they ask questions about it.. just because it may be one in a sig does not mean it is one of them
  17. 9

    Question about LU rebuild + getting ripped off on sale.

    what did you get for $20? I do not think you replaced all the seals and o rings for $20. Did you pressure check the lower to see where the leak was, and pressure check it after the repair to see it it is fixed?
  18. 9

    SUZUKI 1987 DT8

    why not try some air instead
  19. 9

    SUZUKI 1987 DT8

    where do you think you need to hook up fresh water to wash out / flush the motor? finding an owner's manual and service manual would be a good thing
  20. 9

    Yamaha 3hp 3MSHY (6L5) stalling after Carb Leak Fixed.

    just my thoughts, but it sounds like something plugged up or at least restricted the carb jets passages from opening them up
View older results
Top