Search results

  1. Scott Danforth

    VP 2007 3L 135HP engine oil options

    No, not really It is one of the very few cheap high zinc oils. You need zinc for your flat tappet motor
  2. Scott Danforth

    looking at a 1990 thompson 260 fisherman

    the boat is 36 years old. consider it has rot until proven otherwise. you have to drill test to determine rot in your transom and stringers
  3. Scott Danforth

    Keep blowing my starter solenoid up.

    if the purple wire reference to the alternator sense pin calls for more juice, that alternator will try to make that sense pin voltage go above 13.8. as stated, depends on the battery and condition of the wiring.
  4. Scott Danforth

    Need different prop for pulling

    AKI vs RON vs MON The US uses the AKI or Anti-Knock Index which is RON + MON / 2 Your motor is designed to run on 87 octane pump swill
  5. Scott Danforth

    More speed from 9.9 merc

    Go down in pitch That boat is probably rated at 50-60hp. So less than 40hp will be under performing
  6. Scott Danforth

    Merc Alpha One trim/tilt Q (feeling like a newby)

    Copyright laws would prevent anyone from posting a scanned version
  7. Scott Danforth

    Need different prop for pulling

    You are being your own worst enemy here.....Mash that throttle on the holeshot. It's not about speed, it's about getting that large mass moving The 5.0 is still too small for the boat
  8. Scott Danforth

    2014 GMC Sierra AC

    Closing this out. Amazon brought new hoses and I swapped my service connections Checked pressures against the chart Air out the vents just below 60F with a 91F ambient
  9. Scott Danforth

    Rear bimini 94' Sun Tracker party barge 30

    White Water Marine (company that builds tracker boats) never had patterns. they bought the canvas from Dowco and most recently Great Lakes Boat Top you can go on the Dowco website and get canvas. https://www.dowcomarine.com/oem-pontoon-fishing-boat-covers
  10. Scott Danforth

    A question for Mercury outboard techs

    Muc, see your PM's...... going with Right Hand not communicating with left hand
  11. Scott Danforth

    China propeller

    some of the prop manufacturers use off-shore sources. without doing digging, it may be as good as other props. or it may be a really bad knock-off.
  12. Scott Danforth

    Merc Alpha One trim/tilt Q (feeling like a newby)

    you wont find a manual that you can download. short of the manuals listed here https://forums.iboats.com/threads/boat-manuals-owners-manuals.770690/ they do not exist. no, do not run your motor higher than the trim limit. it puts the u-joints in a bind and will wear them out really really...
  13. Scott Danforth

    Let's talk skill...

    yep, perfectly normal the jack-arse in me really really wants to comment on this
  14. Scott Danforth

    VP 2007 3L 135HP engine oil options

    your motor is a flat tappet motor. I would stick with dino squeezings high in zinc, like Rotella T4 15W-40 as for the outdrive, use a marine gear lube that meets volvo's requirements.
  15. Scott Danforth

    Float bags for small bow boats?

    Kayaks are not required to meet ABYC H-8. boats are
  16. Scott Danforth

    Let's talk skill...

    google V-hull wander. all single prop V-hulls do it. duo-prop singles also do it to a slightly lesser degree. Not a thing that you can do to stop it but let it wag back and forth.
  17. Scott Danforth

    Mercruiser dies after getting on temp

    points when cranking get their voltage from the starter "R" terminal (also called "I" terminal). however for normal Key-on, they get power thru a resistor wire, or a ballast resistor to drop voltage to approximately 9 volts. you can run them "hotwired" to 12 volts for a short period of time...
  18. Scott Danforth

    Need different prop for pulling

    unless your motor was built to need higher octane, it will NOT give you more power, it will give you less power and cost you more money at the pump as Octane goes up, the ability for the fuel to ignite is decreased (allowing a higher base timing to move the timing curve). This is increased...
  19. Scott Danforth

    Need different prop for pulling

    when I had a 3.0, I had 3 props with me. a 19p for WOT runs, a 17p for most things and a 15p for watersports as Jimmbo stated, your boat is a bit much for a 5.0 your 3400# dry weight will be closer to 4200 once you add batteries, gear, fuel, etc. I would shoot for a 17p myself if you...
  20. Scott Danforth

    Let's talk skill...

    600 RPM is OK. 800 RPM is too high
Top