Search results

  1. alldodge

    Control cables.

    The shifter
  2. alldodge

    2005 Mercruiser MPI 5.0L misfiring(?) when in gear, idles fine

    No OBD port, boats have unique connectors based on which ECM and Rinda makes the scanners. Can get a TechmatePro or Diacom will need connector 94006. The Techmate is hand held and self contained, the Diacom uses a laptor The lower cost kits in the link have the single connector. The higher ones...
  3. alldodge

    Boats from work.

    :ROFLMAO: :ROFLMAO:
  4. alldodge

    Mercruiser Neutral Safety Switch?

    It is a new thread
  5. alldodge

    MC-1 260 swap

    Alpha History
  6. alldodge

    Mercruiser Neutral Safety Switch?

    Welcome Is the motor cranking and not starting or not cranking when the key is turned?
  7. alldodge

    Trail camera issues fixed, now pics from them ...

    No pic so it didn't happen, but saw a wezel run across the field last week
  8. alldodge

    2010 gtx iS 215 sc slow crank w/ringing sound

    Check the bearings on the supercharger Pull it and have a look
  9. alldodge

    2005 Mercruiser MPI 5.0L misfiring(?) when in gear, idles fine

    Thanks Really need to scan the motor for codes, but until then Do you have mechanical or digital controls, I'm assuming mechanical? The running worst as time goes on is showing that as the motor heats up the ECM starts reducing fuel supply like it should. The issue is the motor needs more fuel...
  10. alldodge

    Question about Bravo 3 conical clutches

    Bravo's are either engaged or not, there isn't a partial I would keep it under 800 rpm
  11. alldodge

    2005 Mercruiser MPI 5.0L misfiring(?) when in gear, idles fine

    You don't want to provide the full serial number, so I'm not able to look up your motor.
  12. alldodge

    2005 Mercruiser MPI 5.0L misfiring(?) when in gear, idles fine

    Good luck
  13. alldodge

    2005 Mercruiser MPI 5.0L misfiring(?) when in gear, idles fine

    What is your serial number?
  14. alldodge

    Bravo 1 to Bravo 3 Conversion

    This is bravoits and happens in salt mostly, hardly ever in fresh
  15. alldodge

    MC-1 Drive Dog failure?

    Most likely it was the upper drive shaft seal
  16. alldodge

    MC-1 Drive Dog failure?

    I don't see an issue with the shift foot play/slop
  17. alldodge

    Broken console to control shift cable

    Adjust the shift interrupter make sure roller is in the bottom of vee when it neutral
  18. alldodge

    Installing Bravo3 Sterndrive

    So long ass alignment checks out, grease it as you have been and give it the Merc kick
  19. alldodge

    Vapor lock or something else?

    The amount of fuel or if it was from winterized fuel has no bearing on what happened. It all deals with fuel pressure and the amount of heat
  20. alldodge

    lost the fuel filer yoke & nut inside the motor can I run the outboard?

    If it's between the leg and outer decorative cowling, than yes, won't hurt anything
Top