Search results

  1. Scott Danforth

    Raw water pump seal on 2012 V8 5.7L

    look at the cover on your pump. it will have Johnsons part number on it.
  2. Scott Danforth

    Raw water pump seal on 2012 V8 5.7L

    this should be it with the wire anti-rotation bracket 10-13614-02 https://www.amazon.com/Johnson-Pump-10-13614-02-Impeller-Malibu/dp/B0D4FJ4B9V
  3. Scott Danforth

    Raw water pump seal on 2012 V8 5.7L

    a new pump is only $175 look up Johnson pumps. you have either a Johnson F5B-9 or the slightly longer F6B-9. the longer (higher flow) F6B-9 is about $80 cheaper than the F5B for some reason. rebuild kits are reasonable too. dont pay volvo for the same pump you can buy yourself. here is a...
  4. Scott Danforth

    I didn't want to restore this 1997 Islander this summer

    that looks like galvanic corrosion. something is literally eating the aluminum. check your electrical grounds. none should be using the boat as a ground.
  5. Scott Danforth

    The internet has no actual information about common boats? 2003 Tempest 165. Google ONLY lists for sale ads.

    For a motor manual, go here. https://publications.brunswick.com/ As far as a boat manual, only about 12 manufacturers (out of 200,000 manufacturers over the past 100 years) have an actual manual, other than the 4-page safety brochure listing the servicing dealers Take a boaters safety course
  6. Scott Danforth

    New motor arrived today

    Can do 3 12 volt batteries wired in series
  7. Scott Danforth

    Loosing Faith in Humanity . . .

    Ted, I have a prop if you need it .....PM me
  8. Scott Danforth

    New alternator, still low voltage

    By clean....use 150 grit and make the terminals shiny enough your mother in law would eat off them If the cables are crunchy, replace them When done, seal the connections with marine electrical varnish
  9. Scott Danforth

    Mystery bolt found in bilge

    Measuring the pic with a ruler shows it's stretched.
  10. Scott Danforth

    Emergency Starter Solenoid

    It's a ~100 amp contactor with isolated ground. Available nearly anywhere
  11. Scott Danforth

    Any reason I couldn't run the engine without the drive attached?

    I run my VP without the drive all the time. I made up a hose that jumps from 1" to 1-1/4 and run the hose directly to the raw water pump
  12. Scott Danforth

    Accessing live well hoses

    When I had to rebuild my ex father in laws boat due to live well plumbing. I spent a day with a small pick digging in the carpet to find the screws. Then another 2 days pulling the boat apart, finding the screws I missed
  13. Scott Danforth

    1993 Mercruiser 350 Ski Magnum carbed oil type

    You're one of those aren't you. You're short circuiting..... Someone who is so enamored with a recommendation made 33 years ago for a motor that is now obsolete by today's standards for an obsolete oil spec that was state of art 35-40 years ago that you short circuit if some makes a suggestion...
  14. Scott Danforth

    1993 Mercruiser 350 Ski Magnum carbed oil type

    Yes, engines in the late 80s and early 90s called for straight weight oil..... Then oil technology got better and the OEMs switched to 20w40 and 20w50..... Then zinc levels dropped as motor technology advanced Don't over think it. The 15w-40 diesel oil is pretty much perfect for a boat motor...
  15. Scott Danforth

    Going rate on a good running 15hp?

    Anywhere from 300 to 1000 depending on condition and geographic location
  16. Scott Danforth

    Boat Keel

    I would probably use boat caulk or 4200
  17. Scott Danforth

    Just thought I'd share a nice photo.

    From our stop at Manatee springs this morning
  18. Scott Danforth

    Prop Shaft Removal Trouble

    ok, here is a video.
  19. Scott Danforth

    Loosing Faith in Humanity . . .

    I managed to sell my two old 50's merc's to an old-merc nut from Canada that was down visiting. I have some other marine stuff that I renewed the FBM listing a few times, get the random inquiry. CL has a bunch of spammers. Ebay is hit or miss. Have a bunch of VP stuff, some old outboard...
  20. Scott Danforth

    5.7L Mercruiser water leak in blige

    that picture looks like the core of the engine mounting pad is rotten to stop the leak, you put the drain back in the Y-fitting
Top