Search results

  1. dingbat

    Suzuki DF140 fuel injector issue code 4-3

    4-3 is a fuel injector failure. Since you swapped the injector with no resolution, the next place at the feedback that triggers the firing of the injector. Typically some kind of crank and or cam position sensor for this feedback
  2. dingbat

    Bone headed move - put the plug in with 3M 4200

    Have you tried to get it out? The tensile strength of 4200 is low and it doesn’t hold very well on metal (bronze) unless clean and primed.
  3. dingbat

    Vin number on a trailer

    Have to get “home made” trailer registration
  4. dingbat

    slight gas in oil 2009 yamaha 4 stroke

    That's news to me.... What years? Bought my first (new) Honda Accord in 1988. Have had at least one Honda, usually two, in the garage ever since. Current daily is a Civic EX with 230K miles
  5. dingbat

    Anyone familiar with the Dual Pro charging system?

    Absolutely nothing........it's a battery charger That charger is designed to charge two batteries at once. Would need to rewire/ move the stereo and depth finder power connections to the "new" battery.
  6. dingbat

    AutoPilot Options

    Problems at speed for trolling? Assuming you have position feedback sensor? If not, it's never going to work worth a darn Cable steer is not the best for slow speed operation. Much different interface today than used 20 years ago. You would be better off a start over with modern equipment...
  7. dingbat

    Tie down caliper mounting bracket

    Stainless steel welding and tapping in the DC metro area? And you thought shipping was expensive.....lol
  8. dingbat

    Is my trailer too short?

    As long as your tongue weight is within spec. I wouldn't worry about it. My boat bunks (4" x 6") and boat overhang the back of the trailer by ~20".
  9. dingbat

    No spark on half the motor!

    TROUBLESHOOTING THE TIMER BASE NO FIRE ON ONE BANK OR 1 CYLINDER 1. Disconnect the Timer Base connector for the side not firing and check the resistance from the White to the Green, Purple and Blue wires. The reading should be approximately 18 ohms to each wire. 2. Disconnect the Timer Base...
  10. dingbat

    Tie down caliper mounting bracket

    https://www.trailerpartsdepot.com/shop/44480g-12418?gad_source=1&gbraid=0AAAAAD_N7SwtszlTP9skznjwZo-faDBe2#attr= I’ve ordered a couple of items from here
  11. dingbat

    1990 Dual Force 120s one side showing 16.7v at speed with dual batteries

    Voltage regulators are simple generic circuits. Schematic is studied in electronics 101 VR dissipate excess voltage as heat. The issue is getting a unit large enough to dissipate the output as “heat” w/o melting. The 35 amp charging system on my 200 hp uses a water cooled regulator. You...
  12. dingbat

    Tie down caliper mounting bracket

    Sounds like the plate is stripped. Seeing lots of “plates” available for sale
  13. dingbat

    Problem Replacing old incandescent NAV lights with LED lights

    Has nothing to do with the "post". The problem you have is that LED operate at roughly 3-3.5 volts DC and your supplying them with with 12 volts. You can either reduce the voltage with resistors. power them in parallel, or power them through a dedicated, low voltage power source. Should just...
  14. dingbat

    No spark on half the motor!

    Check to make sure the shift switch is adjusted correctly. Don't remember which bank of cylinders it shuts down, but I believe it's the starboard bank
  15. dingbat

    Problem Replacing old incandescent NAV lights with LED lights

    He is retrofitting incandescence light circuits with LED
  16. dingbat

    Problem Replacing old incandescent NAV lights with LED lights

    12 DC LED have built in resistors. When you connect LED lights in series, the 12v is going to be divided equally among the LED lights. Thus, if you have 2 LED lights, 6v for each one. If you have 3 LED lights, 4v for each one Would have to wire in parallel
  17. dingbat

    1998 15HP 4-Stroke Water in engine oil after impellor change?

    Text book “making oil” scenario. Motor not getting up to temp to burn off condensation in the oil. Make sure your thermostat is operating correct. Run it hard back to the dock to get oil temps up
  18. dingbat

    Evinrude Vindicator 1996 Won’t Start for an Hour—then Runs Great!! Help!!

    Sounds like same issue I was going through 96’ Ocean Pro Long story…. after working for 6 months, new primer valves clicks but motor does not start. Use red lever, motor roars to life at the turn of the key. Either needle valve is stuck or something plugged up the passages. Still have the...
  19. dingbat

    120VAC NC Remote switch

    https://www.carymart.com/2000m-far-distance-30a-high-power-nonc-relay-output-remote-control-switch-p-1490.html?zenid=uh4fnpb3mief0jo285u6enfcv7
  20. dingbat

    120VAC NC Remote switch

    What problem are you trying to solve? I have a motion activated lights at the barn. Love/ hate relationship until I found a light that you could take in and out of manual mode from the switch. Flip the switch on and of quickly puts it into manual mode. Flip the switch on and off again, put...
Top