Search results

  1. Scott06

    a carburetor shouldn't spill fuel like this, right?

    did the 8 psi pump overflow the bowl
  2. Scott06

    a carburetor shouldn't spill fuel like this, right?

    Merc spec is 4-7 psi which is normal range for carbed engines for the last 65 years. He may have the wrong pump or cheap aftermarket pump that has too much pressure. Carter makes two universal fit marine pumps that put out 4-6 and 6-8 psi respectively. It’s what Michigan motorz supplies on their...
  3. Scott06

    a carburetor shouldn't spill fuel like this, right?

    Would not add a regulator to overcome a malfunctioning fuel pump
  4. Scott06

    a carburetor shouldn't spill fuel like this, right?

    That fuel looks phase separated would not use it Attached screen shot from merc V8 manual 24 says carbed engines 3-7 psi. airtex makes the fuel pump for merc can find them under that name , must be sure to get low pressure one…9-10 psi is too high
  5. Scott06

    1983 merCruiser 3.0 4 cylinder.

    Suspect your gauge is off below 100 is normally A dead cylinder smoking like hell and tons of blow by. if it runs good why did u do the compression check? Try with another tester engine was up to temp ?
  6. Scott06

    Water in Oil (Again) Head Scratcher

    other possible thoght is head bolts that go into water jacket if they were sealed…
  7. Scott06

    NO SPARK!!!! Thunderbolt IV headscratcher

    Follow troubleshooting guide scott posted. Thee are no temp or oil pressure ignition cutoffs on the tbolt. Only cutoff is man overboard switch. If this is tripped will start on starter then die when key goes to run. use oem sensor in dist only. Lots of failures on aftermarket stuff. Achilles...
  8. Scott06

    Water in Oil (Again) Head Scratcher

    If you look at attached screen shot of my 04 200 sport parts manual it shows in each of the 5.0 engine combos on last line in engine shows rsr. The 4.3 options dont have that . Must be with extra weight on stern they wanted risers. Is not your cause as u havent splashed yet. Do the pressure...
  9. Scott06

    shift issue and running with some noise from lower unit gear

    yes this is a good video
  10. Scott06

    Required HP for slalom skiing

    I don't think you can get a 5.7 in these anymore Merc is going from the 4.5 /250 hp to their (not GM 6.2) to the op - is the 250 the biggest engine? Would think you will be ok but might want to get a ski prop. I was surprised skiing behind my neighbors Larson 208 w a 4.3 mpi (220 hp) yanked...
  11. Scott06

    97 baja hammer 454

    What is your current WOT rpm with the mirage? As stated above really very different applications and props. Bravo 1 doesnt seem to be available in pitches lower than 22" , also seems like a go fast prop not a tube puller . https://www.mercurymarine.com/en/us/propellers/elite-series/bravo-i/...
  12. Scott06

    2006 Sea Ray I/O 5.0 mpi shuts off when I put it in gear

    Is this an alpha drive or bravo ? If alpha would disconnect the shift interrupt switch see if it goes in gear without dying If it goes in without dying with switch disconnected would think you need a lower shift cable
  13. Scott06

    Accurate Horsepower Figures

    What prop are u running now and what is the max WOT rpm. When you say too many rpm - to hold the boat on a plane? or max rpm?
  14. Scott06

    Mercruiser 4.3L Will Not Start

    I actually think 30 kv is ok how big a gap is that ? is it blue or light /orange in color? this is at the plugs or coil? if at coil check plugs to ensure you are not loosing spark in distributor This denso article lists 10-30 kv as normal spark strength...
  15. Scott06

    Accurate Horsepower Figures

    If the boat was a 5.0 originally most 5.0's I've seen take a 1.62. Only higher HP like MPI in lighter hulls seem to get the 1.47 drive. Agree with other HP assessments. Your original 2 bbl 5.0 would have been 220 hp. Your 5.7 with MPI or 4bbl carb would be 290 /300 hp. With a 2 bbl 250/260 is...
  16. Scott06

    a carburetor shouldn't spill fuel like this, right?

    You can use a simple fuel pressure gauge, oftentimes places like autozone will rent them to you . Biggest issue you will have to rig up a T to test it. Merc makes a test fitting but it is a little salty for one time use ... Fuel line is 3/8" double flare fitting, probably rig up a fitting to...
  17. Scott06

    Alpha Gen Two trim cylinders

    Thanks for the tip they doent seem to offer much in way of mercrusier items only the gland nut, which is where i have the leak. looking at it today, the shaft coming out has a weird discoloration or spots on the chroming different from the other side that is not leaking. i think im just gonna...
  18. Scott06

    5.0 MPI Misfire Under Load

    This was the first thing i was gonna mention the crab caps on mpis are a known trouble spot. Good place to start
  19. Scott06

    Engine inspection tips for used 4.3L V6 or 305/350 V8 equipped mercruiser I/O setups.

    They should be willing to run and water test the boat. If not assume there are issues. your list of look fors is pretty good. Issue is with no load on the hose doesnt mean much. Conversely if yiu have a successful water test the boat should sell for more. When i sold my old boat 7 years ago i...
  20. Scott06

    So I ended up sinking a bit.eek! 82 sea ray

    Get the water out of the engine crankcase replace oil, take spark plugs out spin engine to expel any water from combustion chambers and get it running. Dont let the water sit in there. Then repeatedly change the oil until it runs clear.
Top