Search results

  1. dingbat

    Output voltage

    You do realize the input (two posts) are AC and the output is DC? Outboards don't generate charge current below 1,500 rpm or so
  2. dingbat

    Battery operated small room A/C units , WORK ?

    Can't comment on the A/C part but have experience with attempting to sleep in a GW Walkaround. Tried it once and never again. Very cramped and no ventilation even with the windows open unless you leave the door cracked then the bugs eat you alive. Ended up sleeping in the truck to get away...
  3. dingbat

    Output voltage

    I would bet an ice cream sandwich that your battery needs replaced. Batteries typically don't fair well after being run "low" What is battery voltage one hour after removing it from the charger? When was the last time the battery was load tested?
  4. dingbat

    Blue sea circuit breaker help

    The short answer is just 1 battery in the "ON" position. The switch is designed to be used with two isolated battery banks with an ACR managing charge distribution from a common charge source while maintaining the isolation between banks. The switch does not share a common source unless put on...
  5. dingbat

    Anyone familiar with Hynautics Hydraulic Steering?

    Nothing special about any of the steering cylinders. Shaft seals and orings are commercially available. Just tear it down and source the components individually.
  6. dingbat

    Proline 2002 23 WA Scuppers on deck are clogged

    The nozzle of the hose fits perfectly in the thru hull on the outlet. A couple of blasts with full water pressure in the outlet followed with a couple of full pressure blasts in the drain typically opens the drain
  7. dingbat

    Fuel gauge

    Senders utilize resistive loading. You need to measure the output in ohms.
  8. dingbat

    If you have a roller trailer used in salt water....check this....

    Our tides are in the 1 to 1.5' range. We are very fortunate in that we have a lot of well maintained boating infrastructure. This is three of ten double wide ramps at our local State Park The one thing I noticed is the boat sits about 12" lower and the trailer is about 2.5' longer. Based...
  9. dingbat

    Wiring a water temp gauge.

    How do you know it over heated? If you got an alarm the "other" plug is the temp switch that triggered the alarm. With a temp switch already in place, I prefer a pressure gauge to alert me to the loss of water pressure prior to it over heating.
  10. dingbat

    Storing fishing poles in gunwale?

    Depends on what rods you're storing. That setup works OK for holding #20-30 trolling rods but beats the heck out of the reels if stored without reel cases. The length and small diameter of spinners make it even tougher on rods in those holders Since you have a center console, I would use...
  11. dingbat

    Raymarine Multi Function Display Flickering

    Describe "flicker" Guessing a loose connection or flakey fuse holder
  12. dingbat

    Looking at a 1987 Bayliner 2160 Hardtop ???

    The hull is rated to 230 Hp. Wouldn't want to be out on big water when push comes to shove that under powered
  13. dingbat

    Tightening stripped screws in hatch lid hinge in fiberglass

    Cutting threads in fiberglas is problematic due to its lack of deformation when worked. You get better results "molding" threads in place. To that end, the easiest way to repair a stripped thread in fiberglas is with Marine-Tex. Drill out holes using next size up drill bit to make good clean...
  14. dingbat

    How to decarb an outboard?

    For years I used “Dunk’s” method and just poured a can of sea foam in a 1 gallon gas can. Pulled the fuel line off the fuel pump, attached a length of fuel line and drop the other end in the can of mix. Fired up motor and let it idle until the can was empty, shut off the motor and let it sit...
  15. dingbat

    If you have a roller trailer used in salt water....check this....

    My first boat came with a single axle trailer. Hated that thing with a passion. A balancing act if the trailer wasn’t hitched to the truck. Done with roller trailers in general. Getting too old to walk the tongue to hook up the winch. Went with the Loadrite aluminum I-beam bunk this time...
  16. dingbat

    Trout

    I understand from the locals that they get much larger but…having grown up hand lining trout in the small creek behind the house, that was a fish of a lifetime. Only fish I’ve ever had mounted
  17. dingbat

    Adding a Battery isolator

    Make it easy on yourself and run the positive wire from battery 1 to battery 2 terminal on the on-off-both switch. Surprised they are not specifying fuse when tying the 2 batteries together like that.
  18. dingbat

    Trout

    Used to head up the Lake Ontario every Spring to fish for Steelhead. Caught this 27.5”, #8.5 Brown in the process.
  19. dingbat

    If you have a roller trailer used in salt water....check this....

    Those bolts still have a lot of life left in them…lol Here is what I found this Spring when I went to investigate why the boat loaded with the bow sitting a couple inches off center in the bow stop. Despite the thru bolt probably in the same condition as those above, and the nuts completely...
  20. dingbat

    Solar pool heater water flow question(s)

    Aa I said earlier, the #80, 3/4” HDPE in my system is over 25 years old. No explosions yet….lol
Top