Search results

  1. Faztbullet

    Hooked hull repair?

    Thats a major repair not just a fill in. Filler is for skim coating.
  2. Faztbullet

    Repairing Plexiglass Windshield

    Try some MEK...That what a friend uses to make display cases
  3. Faztbullet

    1987 Mercury Carburetor 60 hp problem

    Sounds like a fuel baffle plate....just bend the tab a tad so it fit carb lip tighter and install new bowl gasket.
  4. Faztbullet

    Mercury 500 Strange Ignition Problem?

    switchbox or stator. flip red and blue wires if problem stay on 1 an 2 its box.
  5. Faztbullet

    1998 OMC 200HP Carb adjustment

    Purple/grn on same side are cylinder #4 and #6 and controlled by advance coil..so diode or resister failed.
  6. Faztbullet

    1998 OMC 200HP Carb adjustment

    Screws initial setting is about 5 turns out from light seat. Motor has to be in water, in gear, untied to adjust . You will find that all will be from 4-3/4 to 6 turns out depending on cylinder conditions. I have replaced ton of these triggers due to resistor/diode failures in QS feature. My...
  7. Faztbullet

    1984 70HP evinrude recently had heads milled .015

    .020-.030 is normal clean up on a lightly ring damaged head...adds maybe 3-5 psi
  8. Faztbullet

    New 1993 Evinrude 48spl

    If your going to do any water sports get a 2 size smaller prop and watch RPM. The gearcase will not live under heavy loads on these motors
  9. Faztbullet

    Bass boat paint peeling

    Someone sprayed it with a automotive clear coat...that's what's peeling. Strip er down but no matter whats put back it will never be shiny.
  10. Faztbullet

    Paint match Yamaha Cover with aerosol

    Look at part# for cowl....ending digits are color
  11. Faztbullet

    1990Yamaha 175 Steering Issue?

    Get ya one of these and pump penetrating oil into steering shaft thru zerks. Amazon.com: Innovative Products Of America 7862 Grease Joint Rejuvenator: Automotive
  12. Faztbullet

    Losing a cylinder

    Recheck compression...reving it up to clear it is not a CDI issue..
  13. Faztbullet

    E225TXCUB

    Small bore 225 open deck motor...gas pig
  14. Faztbullet

    1987 150 xr2 trim tilt bleeding

    Capacity is just a tad over a quart..fill it so its when operating properly that oil level is just below fill cap fully trimmed up. Mark your problem is either the manual release is faulty or down pilot valve in pump
  15. Faztbullet

    Water intruding into cylinder

    I suggest start looking for a different motor of near same year and swap powerheads with know running on and existing one for parts..
  16. Faztbullet

    35HP Took head off and one extra dirty and one clean

    Cylinders need bored...looks like it may have gotten really hot at some point.
  17. Faztbullet

    1987 150 xr2 trim tilt bleeding

    Yes
  18. Faztbullet

    Wiring diagram for 2002 mercury 90 hp

    Rectifier/reg failed....
  19. Faztbullet

    Water intruding into cylinder

    Either inner baffle plate warped/gasket blown out, lower seals bad. cracked block or chipped reed. If inner baffle plate has blown need to have block resurfaced to true flat and new plate with resiweld epoxy.
  20. Faztbullet

    35HP Took head off and one extra dirty and one clean

    +1 on da junk
View older results
Top