Search results

  1. Scott06

    Almost back together, but a shifter issue

    Good thing is you only gotta learn it once, guarantee you won’t forget it …
  2. Scott06

    4.3 Engine coupler issue?

    Is it possible one of the rubber insulators that goes between the coupler and flywheel got knocked off during assembly ? Might be worth popping off flywheel cover before buying a new one
  3. Scott06

    Yamaha Sterndrive Engine Coupler

    You may change your mind about the swap after u look at current boat prices… Only source is used best bet type in part number on google search There is a complete Yamaha drive incl coupler on eBay now but is expensive
  4. Scott06

    Bad knock and then not...Hydrolock?

    Pull plugs out and crank it over hydro lock would push water out of plug holes
  5. Scott06

    New to boats and about to burn down my boat. Need some help with wiring.

    Wiring diagram attached
  6. Scott06

    New 5.7 overheating

    You are also likely getting some water into the cylinders this way
  7. Scott06

    New to boats and about to burn down my boat. Need some help with wiring.

    The thunderbolt modules are made by denso. Here is the TB troubleshooting guide https://forums.iboats.com/threads/how-mercruiser-thunderbolt-ignition-systems-work.676476/ did u test the sensor inside distributor by tapping the wire to ground as seen in the guide? some of the newer engine...
  8. Scott06

    Runs great on muffs but not in lake

    When it won’t start back up do you have spark ? If not would check shift interrupt or disconnect it to test( won’t come out of gear though) If you have spark dump a little gas down the carb if it fires for a bit then it’s fuel related Just need to determine if you have spark issue or gas issue
  9. Scott06

    1991 Mercuiser 4.3 ignition system update

    Install instructions http://marineengines4less.com/images/companies/1/EST%20Ignition%20Instructions%20-%20ME4L.pdf?1431462059320
  10. Scott06

    Mercury 3.0 EST no spark

    Yes especially if aftermarket seems to be common issue going in and out of base mode You won’t make power with out any advance
  11. Scott06

    Sporadic power/throttle performancePCV oil leak

    This is good advice see whats in the filter, probably carb related. Would verify timing is ok as well
  12. Scott06

    GM 350, Mercruiser MIE 260, the spark coil arcs over to the coil nuts a lot

    Only time ive seen that is when i had the coil wire off the cap was testing spark and didnt have it grounded so coil energy had no where to go. Would look at your cap and rotor as i assume the spark is looking for somewhere to go also inspect the wire replace as needed but i think u are loosing...
  13. Scott06

    Sporadic power/throttle performancePCV oil leak

    Yes i think there is a safety wire on the bolt losen it back the bolt off. thats actually a lot of room compared to some boats…
  14. Scott06

    Concerned about Hull Config / Cramped Engine Bay

    21 ft is fine for an IO. Yes In salt or brackish go OB but like you I boat in fresh water and IO is king. I wouldn’t trade my full width swim platform for and OB While I prefer the full bench in the back you end up back heavy when four people are sitting there and u are pulling up skiers … if...
  15. Scott06

    Alpha One II grinds in reverse

    As long as you mark where you were before adjusting you can always put it back and be no worse off. one issue i ran into adjusting mine (2003) is the barrel nut was factory peened onto the cable thread So you cant adjust it.
  16. Scott06

    Size of outboard

    Exactly. Haven’t seen that or the i wish i got a smaller engine yet.
  17. Scott06

    Size of outboard

    Agreed also likely lighter especially with a 2 stroke vs the newer and heavier 4 strokes
  18. Scott06

    Alpha One II grinds in reverse

    Likely your cable or linkage in bell housing is hanging up causing delayed shift Into gear and tripping the interrupter I would disconnect the lower cable at shift plate should slide in and out easily with two fingers You can try adjusting it like this video Again likely with age of boat...
  19. Scott06

    Bellows installation took

    Yep
  20. Scott06

    Size of outboard

    Sounds like some jealousy. Why don’t you keep your condescending comments to yourself and just answer the guys question.
Top