Search results

  1. Bondo

    What parts can I use from a 73 140hp for a 69 120hp

    Ayuh,..... Compare the parts, if they look similar, they'll probably swap over,...... 'n, nope, nothin' to special with a scrap '73 3.0l motor,....
  2. Bondo

    Sheared water plug on block

    Ayuh,..... Just drill a hole through it's center, 'n try to back it out with an easy-out,..... If ya wanta heat, 'n quench it, do it after ya drill the hole through it,..... Once it's out, get a plain ole brass 1/4" pipe plug for it,....
  3. Bondo

    Sheared water plug on block

    Ayuh,..... Do you mean 1/4" pipe,..?? There are no 1/4"-20 plugs in the block,.....
  4. Bondo

    Inline 6 250, 165hp water in oil

    Ayuh,..... Don't start new threads about the same topic,..... Thank you,.....
  5. Bondo

    Shift cable brass pinned to threads

    Ayuh,..... For quite some time now,..... Don S brought me in,....
  6. Bondo

    Shift cable brass pinned to threads

    Done
  7. Bondo

    MC-1 Lower Housing Part ID...

    Ayuh,..... That's the shift spool, with the ssteel washer on top of it,.....
  8. Bondo

    No power to new Kenwood stereo reciever

    Ayuh,..... My guess is, the red wire powers the unit, 'n the yellow wire preserves the memory,......
  9. Bondo

    Dead rise question

    Ayuh,..... Less dead rise, a rougher ride,.....
  10. Bondo

    Cooling Hose Fit Problems

    Ayuh,..... The hose looks right, the P/S cooler is usually right up under behind the motor mount, where it's tough to get too,......
  11. Bondo

    Second Happiest Day . . .

    Congrats Ted,...... I remember when you were lookin' for that boat,.... ;)
  12. Bondo

    2004 Glastron GX205 w/ Volvo Penta 5.0 Overheating

    Ayuh,..... Welcome Aboard,....... I'd investigate the plumbing from the outdrive to the raw water pump,.... If there's a leak there, it'll be suckin' air while on-plane, 'n water when not on-plane,....
  13. Bondo

    engine stalls when shifting back on forth a lot

    Ayuh,...... Never slow shift an Alpha, 'n Yes, it could very well the the root cause of yer "problem",.....
  14. Bondo

    Tahoe deckboat sink fuse is blowing

    Ayuh,..... Welcome Aboard,..... It sounds like both the wire from the fuel tank sender, 'n yer pump are seein' a dead short to ground, so I'd try to find someplace those wires run near each other,.....
  15. Bondo

    1985 Chris Craft Scorpion 168 I/O

    Ayuh,..... Welcome Aboard,...... What motor,..??..??
  16. Bondo

    Carb Recommendations for 5.7L Vortec?

    It's pretty easy with a napa, or harbor freight tubin' bender,.....
  17. Bondo

    Impeller Badly Damaged...

    Ayuh,.... Before you put it back together, put yer garden hose into the t-stat end of the in-comin' water line, 'n let 'er rip,...... That'll flush out any debris that might cause later issues,.....
  18. Bondo

    Engine temp question

    Ayuh,..... How long ago was the impeller changed,..??
  19. Bondo

    Carb Recommendations for 5.7L Vortec?

    Ayuh,...... Donno whether Merc ran the Weber carb/ mechanical pump or not,.... I know there's Merc fuel lines available for the electrical pumps,.... A length of steel or cupernickle 3/8" brake line, a couple brake line fittings, a bender, 'n flarin' tool, 'n you can knock off a custom fuel...
  20. Bondo

    Electrical issues

    Ayuh,..... What Scott said,.... Especially the ground connections,....
View older results
Top