Search results

  1. alldodge

    2002 Chaparral 286 SSI

    It's has to be one or the other. Maybe wiggle handle slightly while trying
  2. alldodge

    Mercruiser 2011 3.0 TKS issue

    The oil is of no concern, it should be coming from a hose coming from the valve cover to flame arrestor. If dripping take top off and measure height. If height is correct then probably needs the needle valve and seat replaced The float weight might be an issue but in most cases no
  3. alldodge

    5.7 Indmar Crazy Fuel Pressure

    I'm going to need to research. A pump pumps X amount of pressure which is more the needed and the Reg lowers to required limits. Only reason for pressure to not be we're it should be is restriction, bad pump or Reg
  4. alldodge

    Hesitation at 2000 RPMs

    With it pinging need to check timing. I would post how to check but don't have my laptop. Search HSV timing and should be able to find
  5. alldodge

    Water Spraying!!

    Vids don't work, sound only As Grub mentioned its the rear seal of the raw water pump
  6. alldodge

    Confusion

    Welcome Marine grade ply is not necessary, most use BCX exterior ply
  7. alldodge

    5.7 Indmar Crazy Fuel Pressure

    Really that's all, what year? Low pressure is either a restriction, bad pump or regulator As Foggy mention, pull the tube from the tank to see if it's clogged Then check lines and fittings
  8. alldodge

    5.7 Indmar Crazy Fuel Pressure

    Welcome To get the folks a bit more info is which Indmar 5.7 do you have? I'm seeing fuel pressure from 40 to 60 psi
  9. alldodge

    2002 Suzuki df70 overheating

    Welcome Don't post in FAQ section, I moved your thread so it can get more looking
  10. alldodge

    Replacing old 2 stroke with newer 4 stroke advice?

    A 125 2 stroke weight is about 350 lb A 115 4 stroke Merc list 363 lb Many folks swear by Yam but for me it depends on who is around to fix something I cannot fix, so I went with Merc Verado
  11. alldodge

    2 Mercruiser-1's stuck in same way

    ok, reattach the cylinders and place 2x4 above the drive so when trim moves up it contacts transom housing. Let the hydraulics do it
  12. alldodge

    2004 Mercruiser 3.0 Aplha One won’t start

    Don't start another thread on same subject, threads merged OK, prove me wrong What was the voltage at the coil with key ON and while cranking?
  13. alldodge

    Replacing old 2 stroke with newer 4 stroke advice?

    And don't forget the 4 strokes are heavier. A 90 4 stroke weighs more then a 90 2 stroke, going to 115 make sure your boat can handle the weight
  14. alldodge

    Trim pump hoses replaced

    Any hydraulic cylinder should never be able to be moved by hand. Being able to do so means the cylinders internal seals are shot, or the pump valving is shot
  15. alldodge

    3 month old Tahoe T18 dashboard screen, radio, horn not working

    Welcome It's 3 months old why not contact the dealer? The horn and radio in most cases has power full time so long as the Battery switch is on. Check for a fuse near the Battery or follow the horn button back to where it's being fed
  16. alldodge

    Carburator

    Mikes carbs
  17. alldodge

    5.0 GXI C no start

    Spark test
  18. alldodge

    5.0 GXI C no start

    This is for V6 but yours will be the same
  19. alldodge

    2 Mercruiser-1's stuck in same way

    ^^agree Guessing the drive has not been off in a while
  20. alldodge

    2003 FW freedom 180 3.0 recent first start since October 2022.

    It shouldn't, might sound different but a healthy motor will not die if mix gets a bit richer
Top