Search results

  1. Scott Danforth

    Trailer ladder?

    for a trailer mounted ladder? or a bow mounted ladder? all for making a trailer mounted ladder. something a bit heavier than the RV ladders. 1-1/4" EMT and 1" EMT makes a good ladder for not a lot of money if you have a welder handy. for a bow mounted ladder, that would be something else...
  2. Scott Danforth

    Where can this water be coming from?

    While the inline 6 has a lot more iron than a SBC or other motors, knowing what damaged the core plug is important.
  3. Scott Danforth

    2023 Splash of the Year Nominations!

    FWIW, Micky should be splashing his other boats today.
  4. Scott Danforth

    Fuel injected parts no longer available

    based on a different thread, the OP is looking at a mid 90's Ford motor with an OMC or OMC/Volvo JV drive. https://forums.iboats.com/threads/omc-vs-volvo-drives.770063/post-5899187
  5. Scott Danforth

    DVA adapter vs DVA analog meter for sensor and coil wire testing

    what brand of DVA are you running? even my 25 year old Fluke with auto sense or the free ones from harbor freight work fine for troubleshooting without any adapter.
  6. Scott Danforth

    2023 Splash of the Year Nominations!

    Just found this splash too from @froggy1150 . https://forums.iboats.com/threads/1974-reinell-cuddy-restore.703264/
  7. Scott Danforth

    Astroglass 1989 full rebuild

    You have this
  8. Scott Danforth

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    10 years and 4 months
  9. Scott Danforth

    Engine choice

    The gen 2 is a much better drive
  10. Scott Danforth

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    Kev.... In Micky's defense, your project is taking a bit of time and his missus is cracking the whip.... (Just busting your scuppers.....)
  11. Scott Danforth

    2023 Splash of the Year Nominations!

    I nominate @mickyryan s 175 aquasport osprey https://forums.iboats.com/threads/aquasport-175-osprey.741623/
  12. Scott Danforth

    Sun Runner 27.5 manuals needed!

    welcome aboard. The wiring diagram was most likely never published or even documented by Sun Runner. Most of the wiring was done with a sketch back then and the in-house prototype team, then sent out to a harness house to copy. boats generally do not get manuals. back in the 80's they...
  13. Scott Danforth

    Flotation foam

    https://forums.iboats.com/threads/how-tos-and-other-great-information.283508/ links 14, 15, 18, 2, 3, 4a, and 4b as for the wood, exterior grade plywood, marine plywood or coosa
  14. Scott Danforth

    Alkylate fuel?

    dont confuse RON vs R+M/2 octane ratings. your E0 which is what you are calling Rec-90 is a 90 octane on the Ron+Mon/2 US scale. the EU uses only the RON scale
  15. Scott Danforth

    Engine choice

    look for a complete long-tail from 1996 or later. then you get the A1G2 and vortec motor
  16. Scott Danforth

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    Hey Kev @mickyryan will be splashing two this week
  17. Scott Danforth

    Oil Analysis for high-hour 4.5L 250 HP

    the 8.2 is just a GMPP 502 motor. nothing special about it. same motor that you can order from GMPP or Summit or Jegs or your local GM dealer. the early 6.2's were built in-house at brunswick in both stillwater and fon-du-lac with GMPP parts, including the stroker rotating assembly and crane...
  18. Scott Danforth

    Recommendations for outboard powerhead machining work

    start googling blind boring.
  19. Scott Danforth

    Alkylate fuel?

    because pump swill is only $3 per gallon
  20. Scott Danforth

    Starcraft ~ Starmada 2023 Splash of the Year nominations

    I'm not part of the starmada, however going through the posts for 2023, there is one splash I found. So I nominate @Siva283 's boat https://forums.iboats.com/threads/1978-ss-16-restoration.760271/page-16
Top