Search results

  1. Scott Danforth

    2005 350 Mag dropping fuel pressure under load

    Have the injectors tested Test the fuel pump Test the anti siphon valve Check the contents of the fuel filter
  2. Scott Danforth

    2005 350 Mag dropping fuel pressure under load

    Bad injectors will cost you your motor. Have them tested
  3. Scott Danforth

    1988 four Winn horizon 200

    Any 1986 and later marinized SBC. You will have to make sure you have all the OMG bits. However I would look for a 1996 or newer Mercruiser/ alpha combo and replace everything pulley to prop after you make sure the hull isn't rotten
  4. Scott Danforth

    How tight? Leaf Spring Bolts.

    You tighten them to the sleeve The plastic bushing is what moves
  5. Scott Danforth

    1997 90 hp service manual

    eBay for used
  6. Scott Danforth

    Front Deck Rail Replacement on Four Winns Horizon

    Unfortunately most sub 26 foot boats are a assembled with only profit in mind. Not maintenance Pull rub rail Remove all the screws Remove cap. Without knowing specifics, that is all I have.
  7. Scott Danforth

    Front Deck Rail Replacement on Four Winns Horizon

    Rail stanchions either have a threaded stud with a nut and washer from below or a pad with screws from above On smaller boats, the whole cap and deck are usually rigged before the cap is glued n screwed in place. This includes hand rails. If you do not have access, you may have to cut access...
  8. Scott Danforth

    Volvo penta 2008 leaking water on left side of engine

    Freeze damaged. Look for cracks in the block
  9. Scott Danforth

    Front Deck Rail Replacement on Four Winns Horizon

    Most likely the rail was screwed on before the hull was decked. Find a replacement before you worry about how
  10. Scott Danforth

    In storage 13 years, oil turned to jelly

    Replace the impeller, bellows, etc.
  11. Scott Danforth

    1988 Bayliner Capri with a 2.3L OMC Ford cobra

    What trouble shooting steps have you done
  12. Scott Danforth

    Removing impeller

    This is an old thread. Please read the rules
  13. Scott Danforth

    Source for mooring chain/hardware?

    They ship
  14. Scott Danforth

    Materials

    if you have the room and you change the drive ratio, and your mount beds are 4" longer than the 4.3
  15. Scott Danforth

    slow drop on T&T, 1982 50 hp

    agree, either cross-port checks leaking or cylinder seals leaking. being a 40 year old cylinder, going with the seals probably broke down
  16. Scott Danforth

    oil pan SBC

    Center is a 4x4 truck pan and is more of the standard "marine" (industrial engine) offering Usually the dipstick determines the pan
  17. Scott Danforth

    Source for mooring chain/hardware?

    Next time your down here, we can head up to St Pete and I can show you a few marine hardware places
  18. Scott Danforth

    Spectrum Gelcoat Repair Kits?

    my guess the de-emphasis on the color match kits is that too many faded boat owners complained that the new gel wasnt a match to the faded boat or the inventory was getting old here is a link direct to spectrums kits https://spectrumcolor.com/collections/patch-paste-kit I personally prefer to...
  19. Scott Danforth

    Fuel efficiency for long-ish trip

    your best economy will be at idle your worst economy will be climbing the hole your best combination of speed and economy is somewhere between 2500 and 3800 RPM depending on wind, current, speed, load, etc. and will change with the wind your best economy/speed/load can only be determined with a...
  20. Scott Danforth

    Sound deadening

    OEMs use https://soundown.com/
Top