Search results

  1. alldodge

    Asking But Don't think anyone knows

    Yes, still looking I think a 27 would be good enough, but thinking about the 29 Maybe a used 270 with a 8.2 which would have CAT's and pull motor from my cruiser and install in it. 500+ HP in a 27 bowrider Weeee
  2. alldodge

    Asking But Don't think anyone knows

    I might have figured it out, Ilmor is listed as joystick control with the 5.3 the 6.2 is not, and there is the twin thing. Its the most expensive but most of the new 290's with Merc package is joystick but its not mentioned
  3. alldodge

    Asking But Don't think anyone knows

    ILMOR makes a 6.2 430HP and 5.3 365HP So why is the 5.3 cost more then the 6.2? Seeing this on Formula website
  4. alldodge

    Adding a Temperature Gauge

    Being a Merc look for a Tan colored wire, if not there will need to add one. The typical 10 pin harness has all the wires listed
  5. alldodge

    Adding a Temperature Gauge

    This is a woops on my part, thought you started 2 threads of same post but you posted to an old thread and then this one Gauge is pretty simple, Connect sender to sender connection on gauge. Connect 12V and ground to gauge connections and its done. Do use a 12V connection that is switched ON...
  6. alldodge

    Low operating temperature in a Mercury 90

    Welcome, and note not ok to post same question in 2 areas Gauge is pretty simple, Connect sender to sender connection on gauge. Connect 12V and ground to gauge connections and its done. Do use a 12V connection that is switched ON when key is turned to ON
  7. alldodge

    Start and run Mercury 5.7 on stand

    The ECM applies grounds to relay coils to energize them, and this isn't happening. If it was mine I would open the ECM (drill rivets out if needed) and see if it needs to be dried out. If all good then have it tested
  8. alldodge

    Start and run Mercury 5.7 on stand

    Submerged that helps I would replace the relays, but could swap them to see if things change. Local auto parts will have the relays that will work the same, just may not look the same. Could also remove the cover off the ECM to see if it needs drying out If it was salt need to do as Scott...
  9. alldodge

    Start and run Mercury 5.7 on stand

    ok, Check fuses, there is at least 3 of them When power is applied to pin C does the MPR (main power relay) click? When power is applied is there 12V at the fuel pump? Note, power energizes the MPR which powers up the ECM. The ECM then applies a ground to the FPR which would turn the pump ON...
  10. alldodge

    Start and run Mercury 5.7 on stand

    Do you have pin B grounded?
  11. alldodge

    Dean's List gets another motor

    Getting FelPro 17046 OSO folks say its good for STD to .060, has 4.370 bore
  12. alldodge

    Dean's List gets another motor

    What I find with 454 there are cut outs for the valves, the 502 doesn't have them
  13. alldodge

    Dean's List gets another motor

    Does appear the difference in 3601 (6 point) and 3701 (12 point) but it doesn't list the lengths Which Felpro head set did you find?
  14. alldodge

    Dean's List gets another motor

    There 088 GM cast heads Also came across the head gasket issue but think were good with it. 502 STD bore 4.446 454 bored .060 over 4.310 The first 502 head gasket set picked up was larger then the bore of the 454.
  15. alldodge

    Dean's List gets another motor

    Bolts and rectangular
  16. alldodge

    Dean's List gets another motor

    Never thought head bolts would be such an issue. Mistake 1 was to use a 454 as the baseline for the head, wrong. Find a ARP kit 3607 which comes with 3 different lengths and 8 are 5 inches which are to long. Original bolts removed from head were 24 each at 4.187 and 8 at 2.187, with speck...
  17. alldodge

    Alarm and then limp mode 2015 Mercury 50 hp 4 stroke

    If this is a EFI motor look for another sensor on the head. Could be the temp sensor is the issue, otherwise need a scan
  18. alldodge

    "Christmas staff fund charge" on my marina bill?

    Malinials
  19. alldodge

    Alarm and then limp mode 2015 Mercury 50 hp 4 stroke

    If that's the ECM temp sensor then that's what's sounding the alarm, otherwise need to scan the motor to find out what is causing alarm
  20. alldodge

    "Christmas staff fund charge" on my marina bill?

    My marina hasn't started this kind of thing "yet", but they did start charging 5% if a credit card is used. Marina gets charged around 3% and they charge 5. The ruff point is if your paying cash/check you have to ask them to remove it
View older results
Top