Search results

  1. R

    Mercury 1999 9.9 hp

    Shift interlock was used on the 7.5 and 9.8 HP models in the 1970's
  2. R

    Wellcraft or Robalo or Black Fin or BW for CC?

    Have you factored in the extra tax on boats over $100,000 in Canada ?
  3. R

    1977 Johnson 75 Stinger dies when put in gear

    Remove sparkplugs.-----Turn water on for the muffs.----Crank it over.----Does water spray out of plug holes ??
  4. R

    Mercury 1999 9.9 hp

    Mercury used interlock set-up in the 1970's !!
  5. R

    Vintage Mercury Cooling Issue

    Take the powerhead off.-----Inspect washer at top of the water tube.
  6. R

    Mercury 1999 9.9 hp

    Well---You have to sort this out yesterday.-----Water inside an outboard will quickly destroy the bearings
  7. R

    Vintage Mercury Cooling Issue

    Did you inspect plastic washer at the top of the water tube ?
  8. R

    9.5 issues

    Cylinder compression and crankcase compression are 2 different things.-----It is impossible to have 65# compression in the crankcase !!
  9. R

    Mercury 1999 9.9 hp

    No head gasket on those that can leak water into the cylinders
  10. R

    1977 Johnson 75 Stinger dies when put in gear

    Did you have the orifice plugs in your hands , taken out of the float bowl ?-----
  11. R

    Mercury 1999 9.9 hp

    A 2 stroke or 4 stroke ?-----I do not believe it has a head gasket if it is a 2 stroke.----Seriaal # is ?
  12. R

    9.5 issues

    Spending a lot of beer tokens.-----Have you checked the reed valves / crankcase compression ??
  13. R

    1977 Johnson 75 Stinger dies when put in gear

    It works in the driveway because the prop does no " work " when fanning the air !!!-----You may have an issue with water leaking into cylinders from exhaust manifold leaks.----Very common issue on those.-----.----You have confirmed that high speed jets ( orifice plugs ) found in the very bottom...
  14. R

    9.5 issues

    Does spark jump a gap of 5/16" ( 8 mm ) on both leads ?----Checked / replaced fuel pump diaphragm ?-----Thermostat working and not stuck open ?----Adjusting the low soeed needle must make a difference.----If it does not then that suggests an issue with the carburetor !!
  15. R

    Wellcraft or Robalo or Black Fin or BW for CC?

    I would look at the used market.----Put your name on a list at a few big Ontario dealers.----Some excellent trade ins at long time established dealers !
  16. R

    ELECTRICAL CONNECTOR TOOLS

    The rubber plugs referred to in post #1 do not have any locking tabs.---Yes oil or grease makes working on them easy.----The special wee tools ( I have them ) makes it easier of course.
  17. R

    60 hp EFI Loses Power and Runs Rough

    Is this a 2 hp or 400 hp motor.----Why not tell the good folks here.
  18. R

    Stuck water pump impeller

    Post some pictures of the gears when it is apart.
  19. R

    Fuel Carburater Question

    ??----How do you know it lost compression ?
  20. R

    1999 Suzuki DT115 Lower Unit

    Sorry-----Too far away to assist you.-------brown's point marine-----Might be able to help you.
Top