Search results

  1. R

    1985 Evinrude 90 Stops Peeing Intermittently

    Are you testing in a bucket or with boat launched ?
  2. R

    1983 Johnson 70hp Shift rod height?

    Same ting.
  3. R

    Evenrude 9.9hp 1982

    You will need the shift lever and remote adapter kit.-----Needed to mount the remote control shift cable.----Complete kit listed at $160.49 on one site.
  4. R

    98 Evinrude 115 carb adjustment?

    There are 2 different 115 HP models in 1998.----Model # or pictures required.-----Mixing gas and oil at 50:1 or is automatic oiling in service and working properly?-----Post results of a compression test.-----Water pump impeller replaced ?-----Overheat horn tested ?
  5. R

    Mercury 500 identification

    The wrap around cowling is from a 76 / 77 model.
  6. R

    Mercury 500 identification

    Does the motor have those brown / copper decals.
  7. R

    1990 Force 50 HP Bearing Cage Kit Replacement

    There is an o-ring seal between the upper and lower parts of the gearcase.------You should have a bigger bucket / more water for testing.----There is no gasket between lower unit and exhaust housing.-----Is there a drain hole there that is supposed to leak ?
  8. R

    1983 Johnson 70hp Shift rod height?

    it is 21-23/32"
  9. R

    Hole shot hesitation

    They built it for many years.-----Very little fuel goes into the bottom 2 cylinders at idle.----Carburetors ( bottom 2 ) kick in again at around 1800 RPM.----Actually quite simple and reliable.
  10. R

    1984 Evinrude E15RCRM 2 Stroke 15HP

    Install a new water pump impeller.
  11. R

    Hole shot hesitation

    This motor only runs on the top 2 cylinders at idle.----It takes exact set-up on linkages / accelerator pump to transition to 4 cylinders at around 1800 RPM
  12. R

    1957 Johnson RJE-19 35hp flywheel torque

    65 ft-lbs I think
  13. R

    Timing specs 2006 15hp 2stroke

    I doubt that timing is the issue.---Unless the flywheel key sheared.
  14. R

    Super Ugly Pistons

    Typically 0.003" / 0.004" piston to bore clearance----Measured in the correct place.-----Even new pistons have a taper to them.
  15. R

    1967 40hp johnson

    Find wiring diagram at -----maxrules-----mastertechmarine----Just a few clicks and you have it.
  16. R

    Special part 311879 - next best thing?

    I am glad I have 2 of the big factory recommended circlip pliers and the extensions for early hydro-electric units.--------At $150+ each for these ( W7 ? ) units it is satisfying to have the right tools.
  17. R

    Dented pontoon log with tear

    If you want it fixed " yesterday " you have to pay.------If you have time to look around / search / compare / do it yourself you can save a lot of beer tokens.
  18. R

    1991 US Marine L-drive Taking on Water

    I would take big steps in rapid succession away from this boat.
  19. R

    Timing specs 2006 15hp 2stroke

    How did the motor run last season?---- Timing does not go out of adjustment.------If you have running issues then do some trouble shooting.--What is your motor doing / not doing ?----Or what happened if your motor quit ?--
  20. R

    2004 Johnson 50 hp (J50PLSRS) Idle Speed

    But----Only the maximum timing advance is set.-----Idle timing is the point where throttle plates start to OPEN , so it is a linkage adjustment.-----Where the timing is with engine idling smoothly does not matter.-----Sorry , need to read and understand this concept.------Timing is not the same...
Top