Search results

  1. R

    60HP 1989 Johnson outboard low compression

    I would never use ball hones.------Ball hones hide the imperfections in the cylinders.------Makes you think you have good cylinders when in fact there might be issues.
  2. R

    1996 Johnson 50 hp 2-stroke carbs

    About the only difference is the linkages on the outside of the carburetors.-----As far as metering the fuel into the airstream they both work the same.-----What is your motor doing / not doing ?
  3. R

    Buccaneer disassembly questions

    There is no alternator on this motor.----Use a puller with 3 bolts 1/4-20NC to pull the FLYWHEEL.----The 3 bolt holes around the crankshaft are to be used.
  4. R

    60HP 1989 Johnson outboard low compression

    Your local machine shop might have ( believe it or not ) a product called " honing oil "----Mine does and I pick up about 2 liters at a time.-----Or use google to find some DIY substitutes for that fine product.-----Use ---sunnen honing oil ----in your search !
  5. R

    2-Stroke Intermittent Bogging During Break-In (25:1 oil mix)

    Tested with cowling off ?-----Spark is known to short circuit to the latches on these V-4 engines.-----Switching wires around might help.
  6. R

    Recommendation on Force Sealant for Crank

    You must use a sealer with low " filler " content.----Most if not all of the sealer squeezes out .----That gets you metal to metal contact.-----Needed for proper bearing clamp up.
  7. R

    Recommendation on Force Sealant for Crank

    Loctite 518
  8. R

    1987 4hp 2stroke E4BRHCUD Neutral problems

    The spring tab hits the shift rod.----Spring opens and stops driving the propshaft.
  9. R

    What is this hose?

    GPS shows speed over the bottom.
  10. R

    60HP 1989 Johnson outboard low compression

    Perhaps stain marks on the plating have been confused with cracks ?----Owner want to find used rods as new ones might be spendy.
  11. R

    honeymoon over...MFS6D

    Brand new ??----Is there not a warranty ?-----Hurry to your dealer I say.
  12. R

    1959 35hp Evinrude lark solenoid

    Just use ---part # and google.
  13. R

    Evinrude 90 HP VRO overheating.

    Well----Post the model # or pictures.
  14. R

    How to remove the oil seal from a 9.5 evinrude lower unit ?

    Use a dremel type tool to cut / weaken the seal.-----It will come out easily then.
  15. R

    Evinrude E15RCRM 15 HP Outboard Motor Problem

    Just search on U-tube as there are a few.-----1974 to 1992 should be the same process.
  16. R

    60HP 1989 Johnson outboard low compression

    The joint for the caps is cracked at the factory.----I believe these rods are plated before heat treating.----Perhaps stain marks are confused for cracks.
  17. R

    Carbs from 1989 60 on a 1995 50?

    I give up.
  18. R

    1959 35hp Evinrude lark solenoid

    0377363 should be at any dealer that knows a bit about older motors.----Shows 10 in stock online too !!
  19. R

    1959 35hp Evinrude lark solenoid

    Find the wiring diagram at -----maxrules -----mastertechmarine----Then do the checks on your motor.
  20. R

    60HP 1989 Johnson outboard low compression

    Are you 100% sure the rods are cracked ?
Top