Search results

  1. R

    1971 25hp evinrude carb adjustment

    High speed jet is a calibrated hole.----No adjustment.-----Why are you cleaning the carburetor ?----What is the motor doing / not doing ?
  2. R

    Evinrude 115 hp 1987 how to replace pressure relief screw 0 Ring gasket

    I assume you mean the manual release for power trim / tilt.----You remove circlip ( installed at the factory ) and remove the screw.------Replace o-ring.-----Install screw.-----Install circlip.
  3. R

    78 Johnson 115 Cold start Issue

    No point guessing.-----Have your battery load tested !
  4. R

    Hard cold start

    Operate primer bulb till it goes firm.----In neutral.---Pull choke out.-----Perhaps remove top of airbox to confirm that choke plate is CLOSED and stays closed.------Turn throttle grip to neutral stop.-----Ignore markings on the grip.----Pull rope.------But the motor must be in good...
  5. R

    2000 Johnson 25hp 3cylinder. Help

    If the oil injection is still in service it should be taken off.-----Heaved away over the fence as far as you can.----Mix at 50:1 in the tank.
  6. R

    Drive Shaft ruined?

    They made thousands of these motors over the production years.----Not all were left in the water 24/7 in my opinion.-----Lots of good used shafts can be found.
  7. R

    78 Johnson 115 Cold start Issue

    Adjust the choke solenoid.----And have your battery load tested.-----A fast spinning flywheel is needed to get near instant starting on these fine motors.
  8. R

    1972 Merc 650E 3 CYL....fuel system Qs

    Hook up a timing light to #1 cylinder.----Lay the timing light on a seat or the floor.----Observe the flashing light when motor falters.------Intermittent flash / no flash means ignition issues.------Repeat with # 2 and #3 cylinder.-----I would carefully inspect all wiring on this...
  9. R

    1972 Merc 650E 3 CYL....fuel system Qs

    Simply ignore the color shift on this. fuel system !!!---Certainly not caused by a torn gasket either.--It is an optical thing.----My filters are spin on water separating filters.-----Right out of the tank before the fuel pumps.-----On a 235 HP 1982 Johnson.-----Fairly thirsty motors.-----No...
  10. R

    Part no longer available 87 30hp - suggestions?

    If I was ambitious I could likely find one of those washers and measure it.-----But shop time is $0.80 a minute.-----Have a few of those midsections laying around ready to be sent for scrap.
  11. R

    Part no longer available 87 30hp - suggestions?

    Maybe drill a hole in a dime or a nickel ???
  12. R

    1972 Merc 650E 3 CYL....fuel system Qs

    I think the filter before the pump is just fine.----No issue with that on my boat.
  13. R

    Engine won't start in neutral

    David.-----That was likely fixed 11 years ago.-----Start a new thread.----Post model # and what the issue is.
  14. R

    2000 Johnson 25hp 3cylinder. Help

    Most parts were the same for all the production years.-------So what parts are you looking for?----In Canada----evinrudeparts.ca----will help you.
  15. R

    Tilt Trim Problem Evinrude Ocean Pro 115

    Posting the model # of your motor must be done.------And did you find this switch ?
  16. R

    1984 35hp Mercury, won't go in reverse

    If you put your mind to it and understand how the shift works it should be an easy fix !
  17. R

    Tilt Trim Problem Evinrude Ocean Pro 115

    I believe there is a tilt limit switch on the steering / pivot tube.----Starboard side of the tube.----And I believe you can adjust it without the use of any tools !!
  18. R

    2000 Johnson 25hp 3cylinder. Help

    And what help are you looking for.-----They are heavy so do you need help lifting it ??
  19. R

    Drive Shaft ruined?

    In Canada------evinrudeparts.ca-----Might offer you some help.
  20. R

    9322B evinrude 9.5hp (not working)

    I can not see , feel or hear your motor.-----So post the compression test values.-----And does spark jump a gap of 1/4" or better on both leads, yes or no ?----My bet is that you have weak spark.-----And you should install a new water pump impeller before your next outing.-----Oh,----I have...
Top