Search results

  1. Scott Danforth

    Volvo Penta 4.3 Raw Water / Electric Pump?

    So in lieu of a problem you want to change to something unproven Wouldn't researching flow rates and cooling requirements be first step?
  2. Scott Danforth

    looking for this..

    Go to outboardbooks.com and buy an official manual
  3. Scott Danforth

    Volvo Penta 4.3 Raw Water / Electric Pump?

    5GPM is less flow rate than the pump that is on there. What is wrong with the current pump? A new one from Johnson is only $130. Impeller kits only $25 What is the flow rate of your proposed diagram pump with 3' of head pressure?
  4. Scott Danforth

    Fishing with Dad

    The boat will be restored as a tribute to dad. It will be made functional and will get two decals. The name "little boat" which was Dad's name for it since he referred to the other boats as the big boat And a duplicate of his tombstone
  5. Scott Danforth

    Fishing with Dad

    It's been almost 4 years since Dad passed. However 2-3 years prior he brought down the fishing barge that we went fishing in for decades. The old gal came with the gale 12 hp that is on there and two old mercs. A Mark 7 and a Mark 20 that I have long since sold as they never really were used...
  6. Scott Danforth

    Advice on a 4 winns restoration

    just like every restoration 40 years ago, fourwinns was an OMC company that was pumping out 18 boats a week. quality was not high on the list. getting them out the door fast was.
  7. Scott Danforth

    1991 4.3 OMC Oil and Water

    my suspicion as well confirmed. winterization failure for two reasons first, its in Houston and that whole area of texas went thru a hard freeze last year second, first run of the year. @bytwnracer .... seriously doubt the block, heads, and exhaust manifolds are salvageable. specifically...
  8. Scott Danforth

    Drain Plug Stuck

    you should have vents on top of the tank.
  9. Scott Danforth

    Hole shot, or up easy?

    at idle you are at displacement speed. burning very little fuel on plane you are at planing speed. burning very little fuel trying to climb the hole, you are burning lots of fuel. save fuel, get out of the hole quickly
  10. Scott Danforth

    Replacement Gas Cap - help needed

    since none of the deck fills are standardized, you will most likely be buying a new deck fill and not just the cap.
  11. Scott Danforth

    A/c malfunction

    start by pulling the impeller for the AC pump and replacing it.
  12. Scott Danforth

    Does anyone have experience with “Race only” push to start system install,

    your key switch on an outboard is for magneto ignition. it also controls the choke. the panel you have is for powered ignition. with lots of know-how, you could get it wired. however the switches will fail. a cover isnt going to help.
  13. Scott Danforth

    Water temp sensor for 88 60hp 2 stroke Merc.

    however it cant. you bought a chinesium special. guaranteed it does not have the correct input for 2-stroke outboards and you would have to read the requirements of the resistance range of the temp switch.
  14. Scott Danforth

    Electric key start not working. 703

    You have the factory manual? If so, everything is labeled
  15. Scott Danforth

    1984 Conroy Ski Boat - Rotten Floor

    My guess when you keep digging, you will find that someone else has been in there No boat builders ever used chip board
  16. Scott Danforth

    Electric key start not working. 703

    Take the factory manual with the factory wiring diagram for the motor and controls, use a digital volt meter and find where the issue is
  17. Scott Danforth

    1984 Conroy Ski Boat - Rotten Floor

    welcome aboard. will depend on the boat construction that you can see and we cant. if you can get to the whole floor, all the stringers, all the bulkheads and the transom without pulling the cap, then do so. however I find it much easier on most boats to just make a cradle and pull the cap.
  18. Scott Danforth

    Racing Tunnel hull - need advice on long shaft vs short shaft motor

    what is wrong with the TOP and speedmaster lower that is in the pic?
  19. Scott Danforth

    Transom repair done, what type of paint for bilge?

    gel if your boat is fiberglass
  20. Scott Danforth

    Information - 3L Mercruiser

    everything in the world requires you to maintain it. that is your car, your boat, your family, your relationships, your health, etc. literally everything takes work to maintain todays outboards have nearly the exact same maintenance requirements as an I/O, with the I/O only having alignment...
Top