Search results

  1. alldodge

    3.0 Cobra with a 4.3 engine?

    It will bolt up by changing the motor mounts on his boat, but he won't like the performance going to your motor
  2. alldodge

    383 strokes conversion.

    Hey @Fun Times night need some help here Don't know what SPX means, and unable to find 8M2005192 Need to find out which ECM/PCM and distributor. If the motor has the flat distributor cap then it does have a Cam sensor, but only uses it if there is a connector is attached. The Cam sensor is...
  3. alldodge

    Washing interior with boat in slip/water?

    Biologist use dawn to clean wild life
  4. alldodge

    Crusader 454 Cooling

    This should be for front mounted HX
  5. alldodge

    Steering Pin Seals MC-1 Alpha 1

    Woops
  6. alldodge

    asking: Alpha gen2 adding grease fitting clarification

    If the pin is pulled to disconnect the steering arm from the ram, it should move easy enough
  7. alldodge

    Crusader 454 Cooling

    Hey @Scott Danforth what say you The issue with BB is its hard on the seals. Might start a leak in the circulating water pump
  8. alldodge

    Crusader 454 Cooling

    I think your good Water pump is moving enough water to keep motor cool
  9. alldodge

    Crusader 454 Cooling

    Would say, if thermostat housing reads close to 160, then you might be ok. If housing is also hot, then look at the circulating water pump on the front of the motor
  10. alldodge

    Crusader 454 Cooling

    What does the thermostat housing measure?
  11. alldodge

    Crusader 454 Cooling

    190 and above is not normal even with closed cooling Have you taken the end caps off the exchanger to see if there is any corrision?
  12. alldodge

    Engine Dies When Hot

    Sounds like a spark issue, but lets do some testing first. What is your motor serial number?
  13. alldodge

    You have insufficient privileges to reply here.

    Its in the FAQ area, no one can respond their, yet folks keep posting in it
  14. alldodge

    Trim sender not reading correctly?

    Yes, that is what I was thinking If it cannot be adjusted to work smoothly, then it needs another sender or its a gauge issue
  15. alldodge

    Trim sender not reading correctly?

    Remove the sender and adjust it so gauge reads down, then reinstall on gimbal and fine tune if necessary
  16. alldodge

    Mercruser Thunderbolt IV ICM Module

    Use some dielectric grease
  17. alldodge

    Steering Pin Seals MC-1 Alpha 1

    No seals on the lower pin https://www.mercruiserparts.com/bam/subassembly/30872/2203/40
  18. alldodge

    350 Mag MPI chugging at higher rpms

    Instead of opening the harness, I would check at the to the PCM connector pins as listed
  19. alldodge

    4.3l over heats on plane

    Place the thermostat in a pan of water on the stove with a thermometer. See if it opens and at what temp
  20. alldodge

    350 Mag MPI chugging at higher rpms

    Need to scan the motor for codes My thought is there is a sensor wire which is disconnected Gray to B-21 (Ground) Dark Blue/White to B-11 (Sense) Black/Pink to B-1 (5V)
View older results
Top