Search results

  1. Scott Danforth

    Think it's restorable....

    The Admiral and I are Camping in Chassahowitzka. Crystal clear water, Manatees, and then I spotted this floating cess pool
  2. Scott Danforth

    1970 Stamas clearwater 24' rebuild

    Build a cradle to support the hull. Cut out all the rotten stuff and start over with everything
  3. Scott Danforth

    What kind of boat is most likely to be equipped with a 3HP electric motor?

    Not sure why you would. They are an appliance like a toaster or blender
  4. Scott Danforth

    Mercruiser 7.4 Starter Grinding/Partial Engagement?

    I would try the helicoil, however you may have to drill out for a timesert
  5. Scott Danforth

    5.0 Mercruiser Problems

    If your compression gauge is correct, your motor may have issues. Hopefully it's just that it has been running rich Get the carb TKS issue fixed, then after running, check again
  6. Scott Danforth

    What kind of boat is most likely to be equipped with a 3HP electric motor?

    Many trolling motors put out more than 3hp Agree with above
  7. Scott Danforth

    Fix chipped paint or do a wrap?

    start by looking here https://forums.iboats.com/threads/how-tos-and-other-great-information.283508/ read links 14, 15, 18, 2, 3, 4a, and 4b in that order and in their entirety.
  8. Scott Danforth

    Top speed?

    on my 16 foot boat with a 3 liter. I carried 3 props. a 19P for WOT running, a 17P for general use and a 15P for water sports and trolling
  9. Scott Danforth

    2003 5.0 MPI problems

    you are 10 psi low
  10. Scott Danforth

    Fix chipped paint or do a wrap?

    you have a lot of fiberglass work to do before you could even re-gel, paint, or even put a decal over it. you have structural fiberglass issues
  11. Scott Danforth

    From question

    you have a hydraulic issue. check your fluid
  12. Scott Danforth

    Missing kickstand on a Force 120

    trailering brackets are usually not installed if there is TnT as Jerry stated, use a chunk of wood or a jack stand
  13. Scott Danforth

    15ft Lowe Jon Boat Transom Repair

    first, unbolt the motor second, cut the welds off the corner moldings third, cut the rivets remove the wood cut all the rivets on the transom skin remove the transom skin and use to make a new skin from a sheet of 11 gauge 5052 aluminum rivet in new transom skin install new wood install new...
  14. Scott Danforth

    1989 OMC COBRA 2.3 Starting in high rpm

    your throttle cable is either broke or disconnected
  15. Scott Danforth

    Substitute for part 862583

    unless the pulley was smashed beyond use, use the pulley you have. if it shows a bit of rust, wire brush and spray with paint
  16. Scott Danforth

    How should I fill this hole in deck?

    why not just reinstall the hatch?
  17. Scott Danforth

    What else will bolt up to Volvo 270 outdrives?

    the whole thing about Volvo AQ series the AQ125 is 125hp the AQ145 is 145hp the AQ271 is 271hp you get the idea.
  18. Scott Danforth

    What else will bolt up to Volvo 270 outdrives?

    I would suggest finding a running AQ125 , or if you really want to change, get a complete longtail and modify the transom as needed
  19. Scott Danforth

    A1G2 decisions. Rebuild or replace?

    Then replace the ujoints and go boating
  20. Scott Danforth

    OMC exhaust flapper alternative.

    Could ditch the log manifolds
View older results
Top