Search results

  1. R

    Tried everything, except what's really wrong.

    What motor ?-----Does spark jump a gap of at least 5/16" ( 8 mm ) on a test device ?
  2. R

    Milky Gear Oil - Now What?

    Time for a seal kit.-------Much cheaper than gears , bearings and shafts.
  3. R

    1965 Ski Twin 33 water intake screen

    Drill out the plug.----Remove screen.------Tap for a pipe plug.----Install new / repaired screen.-----Install plug.
  4. R

    2020 25hp Tohatsu dealer says....not!

    They built a lot of those 48 SPL motors.-----I can not believe you could not find new / used parts to keep it running.----What parts were deemed to be " hard to find " on it ??
  5. R

    1957 35 Johnson (carb adjustment)

    Is the gauge in fact aluminum or the cast iron sleeve.-----If aluminum then a product called ----LUMIWELD-----Might be used for the repair.
  6. R

    gear oil drain plug alternative to slotted screw driver?

    You might find that the Evinrude / Johnson drain plug is the same.--Will fit if Mercruiser uses 3/8-NC thread.---I have seen those hex allen ones stripped as well.
  7. R

    How bad is it?

    There are better more reliable motors out there.----Takes time to find a good one.------Yes it is acceptable to bore one cylinder.
  8. R

    2020 25hp Tohatsu dealer says....not!

    Very valid point.------The older 2 strokes are easy to trouble shoot.----Repair / rebuild.-----The 4 strokes are great when they run.----Start when you look at the key !!--Expensive to repair if you can find a shop with the right mechanics.
  9. R

    How bad is it?

    Going to be expensive.-----Best look for another motor.----Your location ?
  10. R

    Remove quadrant gear and Stern leg is stuck in down position

    Need to use more force to raise the drive.----Sounds like it is jammed by those 2 pins at the bottom.
  11. R

    2020 25hp Tohatsu dealer says....not!

    Some simple trouble shooting must be done by you.-----No one here can see , feel or hear your motor.----I say it is running on 2 of 3 cylinders.
  12. R

    2001 Mercury 25hp POWERHEAD

    Your location ?-----Getting hard to find shops that will rebuild these motors.
  13. R

    How bad is it?

    The 3 cylinder 65 / 70 HP is not high on my " good motor " list.------Remove bypass cover and look at piston / rings.
  14. R

    Tippy aluminum houseboat

    Best to have this thing inspected before an accident happens.-------I like boats designed by a Russian archetect-------Name is ----Kneva Toppleova
  15. R

    Thoughts on an Evinrude 28SPL

    The 28 SPL is the same as the 25 / 30 HP motors that were marketed for many years.------They do have the older ( easier to repair ) midsection and lower unit used in the early 1980's.-----Nothing wrong with this design------You need to maintain and operate it properly.
  16. R

    Another Guy With Force 120 Issue

    All cylinder heads are warped.-----Did you refinish the head before installing the new gasket ?-----A leak into water jackets can lead to overheating !
  17. R

    First tiller motor

    Needs more water in your bucket.----Install a new impeller now.
  18. R

    First tiller motor

    Agreed 25 HP.-----But fill the bucket to overflowing to test water pump.-----Pump is not self priming.
  19. R

    Mercury 7.5 hp Not Firing

    Does spark jump a gap of 3/8" ( 1 cm ) , yes or no ?-----What happens if you put a few drops of fuel into sparkplug holes ?----Does motor bark when you pull it over ?
  20. R

    Mercury 7.5 hp Not Firing

    Switch the plug wires as a test.
Top