Search results

  1. Scott Danforth

    1990 4.3 vortec new motor water in oil

    and the inlet from the transom shield
  2. Scott Danforth

    Maybe my turn for new boat time

    Check your phone :D
  3. Scott Danforth

    Four Winns SL262 (2008) Bimini replacement with wakeboard tower

    reach out to Great Lakes Boat Top or Dowco. one of those two may have made the original
  4. Scott Danforth

    Maybe my turn for new boat time

    what do you need, TACO is headquartered in Miami, I can reach out to coworkers. I myself havent been to MIBS in about 7 years
  5. Scott Danforth

    What´s the best replacement for AQ271C (or 570) 5.7 GM engine, ideally stroker?

    yeah...... us Scotts are like that
  6. Scott Danforth

    Maybe my turn for new boat time

    AD, have fun in Miami. I wont be going this year
  7. Scott Danforth

    Something to Think of While Towing a Boat

    ok, you need a grommet on your brake line...... LOL
  8. Scott Danforth

    Ottertex?

    it was cloth with a vinyl backing. I sprung for sunbrella after seeing that.
  9. Scott Danforth

    Best Oil Extractor

    your motor should have a factory installed drain hose you pull thru the garboard plug hole.
  10. Scott Danforth

    Something to Think of While Towing a Boat

    @Lou C you need a grommet on the holes where your wiring is coming thru
  11. Scott Danforth

    Ottertex?

    get a sample before you start your project..... I didnt like it.
  12. Scott Danforth

    Hour Meter Wiring

    agreed blower should be able to run any time the batteries are on half the boats in existence do not have an hour meter. my key switch has an accessory position that I use for accessory loads. ignition is only for engine ignition, gauges and the hour meter. Hour meter is only used as a rough...
  13. Scott Danforth

    Engine coupler

    inspect the coupler. could also be gears at the top of the drive are toast. pull the cap and look
  14. Scott Danforth

    Volvo 290dp 2.30 lower on a volvo 280dp 1.95 upper?

    wait until you have to pull the motor to address the idle relief flapper
  15. Scott Danforth

    Where can I find this connector?

    call Tige's customer service line and ask
  16. Scott Danforth

    OMC trim cylinders stuck retracted

    check for fluid in the reservoir. you may need to pull the pump
  17. Scott Danforth

    Durbans Johnsonator outboard motors .

    good luck.
  18. Scott Danforth

    Running outboard during freezing temps?

    we used to need to cut ice with a chain saw to get the boat launched for opening weekend of perch fishing in Ishpeming. it was in the teens many times. you will be fine. pull the boat, make sure to tilt down. and flush your livewell lines with RV antifreeze (dont ask why I say this)
  19. Scott Danforth

    Volvo 290dp 2.30 lower on a volvo 280dp 1.95 upper?

    pull yours apart and look at the gears. may not need anything except a re-seal and paint.
  20. Scott Danforth

    Hey Newbies

    @jbcurt00 you could make us honorary sheriffs....... however it may be like Barney Fife with a bullet in the shirt pocket....
Top