Search results

  1. alldodge

    Idiot needs help!!! 2001 5.7 GXI-B TBI

    This is what I have
  2. alldodge

    2005 350 mag (5.7) smartcraft faults Water pressure + fuel level sender

    This changes everything :facepalm: my bad, I was off in the wrong arena Smartcraft uses a CAN bus, but .... that gauge will connect to the data link. The kit should come with instructions, but it basically gets daisy chained form the harness of other gauge. You do have to install the sensor...
  3. alldodge

    Idiot needs help!!! 2001 5.7 GXI-B TBI

    Need to measure your fuel pressure. Place it inline at the TB
  4. alldodge

    Bravo One OD

    Correct, it happens just behind the intake water hose where it attaches to the transom assembly. Not a hard fix, and is usually done when replacing bellows. My 95 Rinker had no signs of it by installed the new design anyway when replacing bellows
  5. alldodge

    94 mercruiser 350 low idle after thermostat change

    Need part number 91806901 or similar. Its a GM TBI test fitting
  6. alldodge

    350 Mag fuel pump cuts off intermittently

    If the plastic block (pis are always best) looked like this, Then its a 90 amp fuse used to portect the engine harness if the alternator shorts out. The fuse is inside the block
  7. alldodge

    Low priority but

    Can we happen to make this little (very little) close mark a tad larger? Open the pic, look and try to close it using a touch pad is real hard, even a mouse is touchy. Sometimes I just give up and arrow back and then find the thread again Low priority but would sure like it if it was a tad...
  8. alldodge

    350 Mag fuel pump cuts off intermittently

    I'm thinking a bad connection, either on the Green wire between Pin A19 and Relay pin 86, or the fuel pump ground (not shown in pic). Could also be a bad connection on the hot side, but would start with ground on fuel pump first
  9. alldodge

    Lost gas cap

    Could use a measurement across the opening, but it looks like the standard 1 1/4 inch fill cap. Perko makes one, and Seachoice has a chrome replacement. Iboats has the whole fitting, but nothing except yam for cap, found the seachoice cap at walmart
  10. alldodge

    1988 Mercruiser 165 4 cyl wont start

    In that case the idle jets are probably clogged up, so it needs to be taken apart and cleaned. Need some fine wire and feed it thru the idle circuits
  11. alldodge

    6.2 mercruiser no power under load

    Guess they need to change their manual 31 (5.0, 5.7, 6.2) because I'm seeing 43 psi at 1800 rpm, the V6 manual 32 shows the same
  12. alldodge

    Determining/Selecting Engine Number/Type

    This may help, found cross reference from OMC to Sierra
  13. alldodge

    I have to take my gas tank out

    Only boats I know of that have wiring diagrams are the high end ones, the regular ones don not. Most use the standard lay out and add more for accessories. That said the boat probably wouldn't need much more
  14. alldodge

    Crossed the battery terminals

    It probably is the ECM, but look for 12V on the Pink/White wires on the injectors. I think the Gi uses the MEFI ECM and if so, use a LED and paper clip on the dlc as shown to see if any codes show up. Install and then count pulses
  15. alldodge

    New user , engine swap need electrical help

    Below is a 3.0 but wiring is the same. Need the purple wire to go to one side of the switch. Look around the motor for a banana plug not being used, if its purple that's your wire. Next the distributor should have a plug on the right (see pic) with 2 short wires and one longer one. The long...
  16. alldodge

    Funny but maybe not

    I setup another LLC and have all my credit frozen. Have credit cards, but always pay them off every month. So I want a business CC and have been unable to get approved because the 3 companies are showing me as frozen. So I get in contact with Transunion and experian and manage to get my...
  17. alldodge

    1984 3.0 mercrusier

    This is the throttle control
  18. alldodge

    No power to guages

    Would follow the red/purple wire back to the fuse and is probably an inline fuse This is your issue There is a 90 amp fuse on the starter post, it looks square and is there to protect the alternator. Put meter on the starter post and you should see 12V. If 12V is there, then check for 12V...
  19. alldodge

    New poster but not new poster

    Been here some time and wonder how many sign in as a brand new poster but actually have been here a long time under another name? Doubt anyone will admit, but for me the dead give away is a first post about doing something dumb, or making an off the wall comment to help back up another post...
  20. alldodge

    Fuel Relay '96 Seaswirl Model 222 Deck Boat

    Will try to assist, and your 5.0 FN would be a Ford motor. I have a diagram for a 5.8 Fi which uses the same colors, maybe it can help
Top