Search results

  1. R

    1956 15hp Johnson electric start question

    Find a donor motor with the parts.-----1956 to 1976 with the 22 cubic inch block.---18 / 20 / 25 HP ------Best way to go.
  2. R

    Removing Cylinder Head 1960 18hp Lightwin.

    I have worked on lots of motors.-----That amount of rust indicates water / moisture was in there.-----How it got in there and over how many years is hard to tell.
  3. R

    1954 18 hp Evinrude Fasttwin Frothy Exhaust

    Those wee handy pumps come with a 3/8-NC thread.-----Very handy to pump oil into the lower unit.----That would be the most common one on the boat shop shelf.-----Not hard to find.
  4. R

    Evinrude 2017 Etec HO 200hp

    They had a production run of X number of motors.-----Sold the same motor for a number of years.----Then a new production run.------Not much different than what others did over the years.
  5. R

    the oil to fuel ratio for Envirude 25 HP E25REIE

    I think most boating people know that these motors run at 50:1.-----And that has been so since about 1964 model years.-----Not secret information.
  6. R

    Removing Cylinder Head 1960 18hp Lightwin.

    Rain water would simply drain down into the engine block / cylinders via the exhaust housing.
  7. R

    1986 25 hp Johnson remote start. Small hoses location

    Does not matter as the 2 wee nipples both put out the same amount of fuel when primer valve is open.
  8. R

    the oil to fuel ratio for Envirude 25 HP E25REIE

    50 parts gasoline for 1 part oil.-----Seller likely is flipping the motor if he does not know ratio.----Or if he has been running it then did he do damage ?
  9. R

    1954 18 hp Evinrude Fasttwin Frothy Exhaust

    Lets start with the model # for this 1954 ?? 18 HP motor.
  10. R

    1994 60HP won't start

    Fuel should PULSE out.----It does not pump with a steady stream.
  11. R

    1994 60HP won't start

    Turn key to on.----Push in and listen for a click.----Use an assistant to push in key.-----Use screwdriver on enricher and near your ears to listen for " action "
  12. R

    1994 60HP won't start

    Are you pushing the key in while cranking it over ??
  13. R

    1958 Evinrude Sportwin 10 hp 10016 Gear Case Question

    It is bulged around the hole for the pin.-----Simply file the bumps around the hole and bearing head will slide off.------Use a dremel ( carefully ) to weaken the seal and it may fall out.
  14. R

    Evinrude 2017 Etec HO 200hp

    Make sure you have a dealer / shop in your area that will help you in case of breakdown , or service is needed.
  15. R

    84 Johnson 9.9

    If we go by the identification plate then this motor has had electric start and battery charging installed at a later date.----Identification plate ( 1983 ) is original I believe.----An electric model would have been J10ECTR
  16. R

    1978 Mercury 110 9.8hp Stop switch question

    Impeller is $25.00------These motors do not have a WARNING system or a SHUTDOWN system.------They will overheat and destroy themselves.
  17. R

    1978 Mercury 110 9.8hp Stop switch question

    That is correct.----Install a new impeller before using this motor.
  18. R

    Johnson 85hp power tilt/trim issues

    Find the plug on the reservoir ( under the tilt motor ) top up with ATF fluid.---Then test.
  19. R

    Can you start these in cold temperatures out of water?

    If that lump of metal is a 20 F you will have to hope it starts and warms up.------Water might freeze in less that 1/2 hr if motor sits in open while you figure it out.-----Best wait for warm spring.
  20. R

    Mercury 500 50hp - year unknown, have questions

    Picture might identify it in seconds.
Top