Search results

  1. L

    Replacing Guages

    I just bought a new Faria guages to upgrage my current set. Boat is a 1993 Four WInns 4.3 OMC. <br /><br />Do I need to change the senders (temp, fuel, trim) to match? The guages that I'm replacing are original and I believe the senders are too...
  2. L

    Bearing Carrier problem

    1993 OMC Cobra 4.3<br /><br />I was replacing some of the seals on the lower part of the drive - shaft seals and the large o-ring that wraps around the back of the bearing carrier. <br /><br />Here's my problem...<br />The bearing carrier is held in by four screws. I either overtightened two of...
  3. L

    OMC Sealing Compound replacement

    1993 4.3 OMC / Cobra<br /><br />Pulled the drive to replace drive shaft seal and the o-ring around the bearing carrier that was faulty. Manual calls for OMC Gasket Sealing Compound (which I cant find) for both the o-ring flanges on the bearing housing and the outdrive gasket. Does anyone know...
  4. L

    OMC Exhaust Plug

    1993 4.3 OMC<br /><br />The plug that needs to be pulled to drain the exhaust manifolds is driving me crazy. It is a brass plug that would acdept a square bit - like a socket wrench, without a socket attached to it. The problem is, a 3/8 socket head is too big and a 1/4 is too small...I've...
  5. L

    Exhaust bellow question

    1993 4.3 OMC/Cobra<br /><br />After pulling drive to reseal the lower unit, I noticed that my exhaust bellow has cuts in it along the bottom. I have searched the site, and some have said that "slits" in the bottom of the bellow are normal, especially if they are aftermarket...Is that true...
  6. L

    Shift Cable Bellow?

    1993 4.3 OMC<br /><br />Just pulled drive to replace seals and cracked exhaust bellow. While I was ordering parts, I figure I would go ahead and replace the shift cable bellow as well (drive bellow was recently replaced). When looking at the transom mount diagram on doug russel, I cant seem to...
  7. L

    Replacing Outdrive seals

    Hello all,<br /><br />Great forum and glad to be a part of it. For this first post, I'm looking for some advice. <br />1993 4.3 OMC w/Cobra drive.<br /><br />Found milky oil on the drive so it's time to replace the seals. Also, the gear oil is slowly leaking from what looks like the prop area...
View older results
Top