Search results

  1. B

    What year is my Honda 8hp

    Could someone tell me what year my Honda 8hp is? Model # BF8A Serial # BACS-1206284 I appreciate your help, thank you...
  2. B

    Johnson 40hp starts then quits

    I have had other posts about the problems I have had with this motor and I would like to update. I have a 1995 Johnson 40hp (Model# J40ELE0) It has a new stator and cdi and a new primer solenoid, new plugs. Now the motor will start every time I hit the key, but runs only a second or two. I...
  3. B

    Weak spark

    I have a 1995 Johnson 40hp Model # J40ELE0 Serial # G03743175 following up from another post, with the plugs installed in the motor the spark gap is less than 7/16" it's more like 1/8". The compression is 180lbs. per cylinder, have fresh fuel, new plugs, flywheel key is good, battery is 13.36...
  4. B

    Johnson 40hp won't start

    Older Johnson 40hp, Has 180lb compression each cylinder, has two new plugs, fresh fuel, and has super good spark. Will not start, pulled the plugs, squirted fuel into each cylinder, reinstalled plugs, won't even fire, nothing at all. I appreciate your help. Thanks...
  5. B

    power trim pump problem

    I have a Mercury outboard with a Electric Hydraulic power trim and tilt system. The electric motor runs in both the up and down directions but the unit does not raise the motor in either direction. I pulled the electric motor unit off to make sure the hex pin between the motor and pump was not...
  6. B

    1974 evinrude 2hp no power

    Well here I am back again. Got the spark problem fixed, now the motor has no power. Starts right up, when you open up the throttle the rpm's go up but not much above a high idle. I can screw in the high speed jet all the way in and it makes no difference the motor runs the same. I did clean...
  7. B

    No spark

    1974 2 hp evinrude ( no spark) new coil, new points, new condenser, new plug wire, new plug. Points set at 20. Made sure the points are not grounding out to the timing plate. Even though the coil and condenser are new I tested them just to make sure. Any ideas? I appreciate your help...
  8. B

    1958 Johnson 35hp seahorse (Model RDE-19)

    The faceplate piece that goes on the front of the air intake that the hi and low speed needles pass through and the choke pull knob passes through, there are two springs that slip over each of the needle jets, can anyone tell me how they go or show me a picture of how they go? I'm not sure how...
  9. B

    1958 35hp johnson

    Greetings; I have a 1958 Johnson 35hp sea horse. I have a carburetor question. does the needle have a wire clip that attaches to the float or does it just sit under the float without being connected to the float. The needle has a groove on top where a wire clip could go but when I took the...
View older results
Top